Miller Electric OM-227 398D manual Threading Welding Wire Through XR-Control Feeder

Page 14

4-5. Threading Welding Wire Through XR-Control Feeder

 

1

Cable Assembly

 

Lay cable assembly out straight.

Tools Needed:

2

Jog Switch

Push Jog switch up to feed wire through

 

2

cable assembly.

1

Ref. 802 193-A

4-6. Adjusting Tension At Feeder

 

 

 

 

 

 

. Hold wire tightly to keep

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Tools Needed:

 

 

 

 

 

 

 

 

 

it from unraveling.

6 in (150 mm)

Open tension arm.

Pull and hold wire; cut off end.

Proceed to Section 4-9.

Thread wire thru inlet guide, along drive roll groove, and into wire conduit. Close tension arm. Adjust tension as follows: grasp spool with one hand, press Jog switch, and turn thumb nut clockwise until motor stalls when Jog switch is pressed. Back thumb nut off slightly.

Ref. 802 193-A

OM-227 398 Page 10

Image 14
Contents XR Aluma-Pro From Miller to You Table of Contents Declaration of Conformity for European Community CE Products Symbol Usage Arc Welding HazardsEMF Information About Implanted Medical Devices+ + − DefinitionsWeee Label For Products Sold Within The EU Symbols And DefinitionsManufacturer’s Rating Label For CE Products Only Duty Cycle And Overheating Specifications− Introduction Torch OnlyXR Control Millermatic 350P − InstallationDo not use gas pressure above 50 psi 345 kPa XR-Water-Cooled Gun Connections Millermatic 350P Water Cooled Gun Connections For Aluminum Push−Pull welding Threading Welding Wire Through XR-Control Feeder Adjusting Tension At FeederPin Plug Information Opening Top Cover Of XR-Aluma-Pro GunThreading Welding Wire Through Gun For XR-Aluma-Pro GunGun Controls Gun Pressure Roll Tension Setting− Operation Shielding Gas Coolant Supply For Water-Cooled Models Only Gun Drive Assembly Maintenance For An XR-Aluma-Pro Gun Replacing Head Tube Liner In XR-Aluma-Pro Guns Changing Gun Contact TipReplacing The Gun Liner On XR-Aluma-Pro Guns Power Pin EndTurn Off welding power source and wire feeder Gun End− Maintenance & Troubleshooting Routine Maintenance For Aluminum Push/Pull GunsCleaning The Gun Liner On XR-Aluma-Pro Guns Gun End Turn Off welding power source and wire feederTrouble Remedy Troubleshooting TableDisconnect power before troubleshooting − Electrical Diagrams Circuit Diagram For XR-Aluma-Pro Gun− Parts List Exploded View Of XR-A Aluma-Pro GunPart Description Quantity 229 Water Head Tube Assembly Of Aluma-Pro Gun Air Head Tube Assembly Of Aluma-Pro Gun − Parts List Including Consumables NumberHeavy Duty FasTiptContact Tips SOCKET/WRENCH Selection Table Standard Metric Material Thickness Reference Chart Service SupportOwner’s Record