Miller Electric OM-1313 manual Replacing Gun Contact Tip, Troubleshooting, See Section

4-6. Replacing Gun Contact Tip

Tools Needed:

4-7. Troubleshooting

Y Turn Off unit.

1 Nozzle

2 Contact Tip

Cut off welding wire at contact tip.

Remove nozzle.

Remove contact tip and install new contact tip. Reinstall nozzle.

2

1

Ref. 800 797-C

Welding Trouble	Remedy
No weld output; wire does not feed.	Secure power cord plug in receptacle (see Section 2-12).
	Check and replace power switch if necessary.
	Check circuit breakers CB1 and/or CB2, and reset if necessary (see Section 4-2).
	Replace building line fuse or reset circuit breaker if open (see Section 2-12).
	Secure gun plug in receptacle or repair leads, or replace trigger switch (see Section 2-7 and/or 4-5).
	Thermostat TP1 open (overheating). Allow fan to run; the thermostat will close when the unit has cooled
	(see Section 2-3).
No weld output; wire feeds.	Connect work clamp to get good metal to metal contact.
	Replace contact tip (see Section 4-6).
Low weld output.	Connect unit to proper input voltage or check for low line voltage (see Section 2-12).
Low, high, or erratic wire speed.	Readjust front panel settings (see Section 3-1).
	Change to correct size drive roll (see Section 4-3).
	Readjust drive roll pressure (see Section 2-13).
	Replace inlet guide, contact tip, and/or liner if necessary (see Sections 2-13, and 4-4).

Wire Drive/Gun Trouble	Remedy
Electrode wire feeding stops during	Straighten gun cable and/or replace damaged parts (see Section 4-4).
welding.
	Adjust drive roll pressure (see Section 2-13).
	Readjust hub tension (see Section 2-9).
	Replace contact tip if blocked (see Section 4-6).
	Clean or replace wire inlet guide or liner if dirty or plugged (see Section 4-4).
	Replace drive roll if worn or slipping (see Section 4-3).
	Secure gun plug in receptacle or repair leads, or replace trigger switch (see Section 2-7 and/or 4-4).
	Check and clear any restrictions at drive assembly and liner (see Section 4-4).
	Have nearest Factory Authorized Service Agent check drive motor.

OM-1313 Page 19