Miller Electric Blue Star 3500 manual Grounding Generator When Supplying Building Systems

5-3. Grounding Generator When Supplying Building Systems

1 2

GND/PE

Use ground device as stated in electrical codes.

23

1Equipment Grounding Terminal

2Grounding Cable

Use #10 AWG or larger insulated copper wire.

3 Ground Device

YGround generator to sys- tem earth ground if supply- ing power to a premises (home, shop, farm) wiring system.

800 576-B

5-4. Engine Prestart Checks (Kohler-Powered Units)
			. Follow run-in procedure in en-
				gine manual.
	1/2 in		Check all fluids daily. Engine must be
			cold and on a level surface. Unit is
	(13 mm)	Full	shipped with 10W30 engine oil.
			Engine stops if oil level gets too low.
			. This unit has a low oil level shut-
	Gasoline			down switch. However,	some
				conditions may cause	engine
				damage before the engine shuts
				down. Check oil level often and
				do not use the oil level shutdown
				system to monitor oil level.
			1	Fuel Valve
			Open valve by turning lever to verti-
			cal position.
			. Close fuel valve before moving
				unit or carburetor may flood and
	1			make starting difficult.
			Fuel
			Add fresh fuel before starting engine
Closed			the first time (see maintenance label
			for specifications). Fill fuel tank up to
	Closed
			1/2 in. (13 mm) from top to allow room
			for expansion. Check fuel level on a
			cold engine before use each day.
			Oil
	Open		After fueling, check oil with unit on
			level surface. If oil is not up to full
			mark on dipstick, add oil (see mainte-
			nance label).
		Full	. To improve cold weather
				starting:
				Keep battery in good condition.
				Store battery in warm area off
				concrete surface.
				Use correct grade oil for cold
				weather.
				Ref. 802 512-A
OM-498 Page 14		Return To Table Of Contents