Simer Pumps 2957-04, 2955-04, 2905-04 owner manual Troubleshooting / Repair Parts, Repair Parts List

Troubleshooting / Repair Parts									5
SYMPTOM			PROBABLE CAUSE(S)			CORRECTIVE ACTION
Pump won’t start or run.		Blown fuse or breaker.			If blown, replace with fuse of proper size or reset breaker.
		Low line voltage.			If voltage under recommended minimum, check size of wiring from
					main switch on property. If OK, contact power company or hydro authority.
		Defective motor.			Replace pump.
		Defective float switch.			Replace float switch.
		Float obstructed.			Remove obstruction.
Pump starts and stops		Backflow of water from piping.			Install or replace check-valve.
too often.		Faulty float switch.			Replace float switch.
Pump won’t shut off.		Defective float switch.			Replace float switch.
		Restricted discharge			Remove pump and clean pump and piping.
		(obstacle in piping).
		Float obstructed.			Remove obstruction.
Pump operates but		Low line voltage.			If voltage under recommended minimum, check size of wiring from main
delivers little or no water.					switch on property. If OK, contact power company or hydro authority.
		Worn or plugged impeller.			Replace pump.
		Anti airlock vent hole is plugged.			Clean out the vent hole with a hat pin or pipe cleaner.
			REPAIR PARTS LIST
	Key No.		Part Description	Qty.		2905-04		2955-04	2957-04
	1		Power Cord	1		PS117-54-TSU	PS117-54-TSU		PS117-54-TSU
	2		Cover, Motor Assembly	1		**		**	**
	3		Inlet Screen	1		PS18-128P		PS18-127P	PS18-127P
	4		Switch Assembly	1		FP18-15BD-P2		FP18-15BD-P2	FPS17-66*

*Replacement vertical switch must be mounted on discharge pipe.

**If the motor fails, replace the pump.

2905-04	2957-04
2955-04

4	4
1	1

2 2

3

3

5916 0109

5918 0109

For parts or assistance, call Simer Customer Service at 1-800-468-7867 /1-800-546-7867