A
WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other part may create a hazard or cause product damage.
• | Remove | the reflector assembly | from | the | spotlight |
| housing. Do not pull on the leads connected to the | ||||
| assembly. |
|
|
| |
• | Remove | the white connection | point | from | its nest in the |
A
WARNING: Always wear safety goggles or safety glasses with side shields when using compressed air to clean products. If the operation is dusty, also wear a dust mask.
housing. |
RETAINER
PIN REFLECTOR
ASSEMBLY
CONNECTION
POINT
A WARNING: To avoid serious personal injury, always
remove the battery pack from the product when cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
A WARNING: Do not at any time let brake fluids, gasoline,
Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a Sears Service Center.
REPLACING BULBS
See Figures 5 - 7.
Over time, the bulb will burn out. When this occurs, replacing the bulb will be necessary. Be careful not to touch the bulb glass. This will reduce the life of the bulb.
To replace a bulb:
•Remove battery from the spotlight and let it cool for at least 5 minutes.
•Turn the bezel counterclockwise to remove.
REFLECTOR
LENS LENS RIDGE
SEAL
TO
REMOVE
_.,,_ REPLACE
NOTCHES
_ | GROOVE | REFLECTOR |
| BEZEL | ASSEMBLY Fig. 5 |
|
|
WHITE
RED CONNECTION
CIRCUIT TERMINAL
LEAD
CONNECTION
POINTNEST
Fig. 6
•Remove the white connection terminal from its connection point.
NOTE: Do not pull white lead without holding the connection point, as this may damage lead.
•Remove the retainer pin from the reflector and remove
bulb assembly. Bulb assembly may be rotated in reflector if needed to aid in removal.
•Install new bulb assembly.
•Replace bulb retainer pin.
•Hold white connection terminal and reconnect white lead.
•Return the white connection point to its nest.
•Align tabs on each side of lens seal with notches on spotlight housing and seat lens seal in place.
•Reattach bezel carefully by rotating clockwise.
•Tighten securely.
NOTE: Always ask for replacement bulb H3 6V55W, number 019020001007.
CAUTION: Do not use a higher rated bulb other than the specified wattage. This could cause damage to the product.