DeWalt DWE4559CN instruction manual Switch Fig, Reduce, When, Trigger Operation

1.Opentheguardlatch(M),andalignthe FIG6. lugs(N)ontheguardwiththeslotson thegearcase(O)Thiswillalignthelugs. M ontheguardwiththeslotsonthegear casecover.

2.Pushtheguarddownuntiltheguard lugsengageandcanrotatefreelyinto thegrooveonthegearcasehub.

3.Withtheguardlatchopen,rotatethe guard(F)into thedesiredworking positionTheguardbodyshouldbe. positionedbetweenthespindleandthe operatorprovidemaximumoperator protection.

N

j_CAUTION:

If

the guard

cannot

be

tightened

by the

adjusting

clamp, do not use the tool To reduce the risk of personal injury, take

the tool and guard to a service center to repair or replace the guard.

NOTE: Edge grinding and cutting can be performed with

Type 27 wheels designed and specified for this purpose; 1/4"

(6.35 mm) thick wheels are designed for surface grinding while 1/8"

O

(3.17 mm) wheels are designed for edge grinding. Cutting can also be

performed by using a Type

1 wheel and a Type 1 guard.

F

OPERATION

_WARNING:

To

reduce

the

risk

of

injury,

turn

unit

off

and disconnect

ff

from

power

source

before

installing

and

removing

accessories,

before

adjusting

or

when

making

repairs. An accidental start-up can cause injury,

4.Closetheguardlatchto securethe guardonthegearcaseYoushould. notbe ableto rotatetheguardby handwhenthelatchisclosedDonot. operatethegrinderwithalooseguardorwiththeguardlatchin openposition.

5.Toremovetheguard,followtheprocedureaboveinreverseorder.

NOTE:Theguardis pre-adjustedto the FIG7. diameterofthegearcasehubatthefactory.

If,afteraperiodoftime,theguardbecomesP loose,tightentheadjustingscrew(P)with guardlatchintheclosedpositionwithguard installedonthetool.

_ CAUTION: Do not tighten the adjusting screw with the guard latch in the open position. Undetectable damage to the guard or the mounting hub may result.

Switch (Fig. 8)

i_ CAUTION: Before connecting the tool to a power source or after a power failure, depress and release the trigger switch (A) once without depressing the lock-on button (C) to ensure that the switch is in the off position. If the trigger switch is locked on, the tool will start unexpectedly when power is reconnected to the tool Hold the side handle and rear handle firmly to maintain control of tool at start up and during use.

TRIGGER OPERATION	FIG.8
To turn the tool on, depress lock-off button (B)
then trigger switch (A). The trigger can be
feathered as long as the lock-off button is
depressed. The tool will remain running while
the trigger is depressed. Turn the tool off by
releasing the trigger.	B	A

14