BM 1609929Y07
Install dust extraction guard with foot plate for masonry cutting applications so that the rotation of the wheel will be towards the vacuum extraction port. Place BACKING FLANGE and DRY DIAMOND WHEEL on the spindle. Thread on the LOCK NUT and tighten nut using the supplied lock nut wrench, while holding the spindle lock in. (Fig. 7)
FIG. 7
SPINDLE
DRY
DIAMOND
WHEEL
!WARNING
!WARNING
cutting.
DRY
DIAMOND
WHEEL
Use only lock nut and flange with equal diameters.
Do not use water or other cooling fluid with this tool for
SPINDLE
BACKING
FLANGE
LOCK
NUT
BACKING
FLANGE
LOCK NUT
Operating Instructions
Hold the tool with both hands ! WARNING while starting the tool, since
torque from the motor can cause the tool to twist.
Start the tool before applying to work and let the tool come to full speed before contacting the workpiece. Lift the tool from the work before releasing the switch. DO NOT turn the switch “ON” and “OFF” while the tool is under load; this will greatly decrease the switch life.
"TRI-CONTROL" PADDLE SWITCH
(Models 1821 only)
The
TO UNLOCK SWITCH AND TURN TOOL "ON": Push paddle lever FORWARD (toward the spindle) then squeeze the paddle lever.
TO SWITCH TOOL "OFF": Release pressure on paddle lever. The switch is spring loaded and will return to "OFF" position automatically.
The
TO LOCK SWITCH "ON": After paddle switch has been activated push paddle lever completely FORWARD and release paddle lever.
TO SWITCH TOOL "OFF": Squeeze and then release paddle lever. The switch is spring loaded and will return to "OFF" position automatically.
PADDLE SWITCH WITH "LOCK-OFF "FEATURE (Model 1821D only
The Paddle switch enables the operator to control the switch functions of
TO UNLOCK SWITCH AND TURN TOOL "ON": Push paddle lever FORWARD (toward the spindle) then squeeze the paddle lever.
TO SWITCH TOOL "OFF": Release pressure on paddle lever. The switch is spring loaded and will return to "OFF" position automatically.