Lock-On/Lock-Off Switch Fig, Fine Adjustment FIG

English

2)Unlock the plunge lock handle.

3)Lower the router carriage until the cutter is in contact with the workpiece

4)Tighten the plunge lock handle by turning it clockwise.

5)Turn the height adjustment knob counterclockwise until it hits the revolver depth stop (Fig. 5).

6)Set the quick adjuster to zero, by turning the inner ring knob clockwise.

7)Adjust the depth of cut by rotating the height adjust knob clockwise to the desired depth of cut. The adjustment range is indicated by the arrow.

8)Tighten the plunge limiter by turning the depth stop bolt clockwise.

TRIPLE DEPTH ADJUSTMENT USING THE REVOLVER DEPTH STOP (FIG. 5)

The revolver depth stop can be used to set three different depths. This is useful for deep cuts, performed in steps.

1)Place a depth template between the depth stop and the revolver depth stop to adjust the exact cutting depth.

2)If required, set all three screws.

FINE ADJUSTMENT (FIG. 6)

Use the fine adjuster when not using a depth template, or if the depth of cut needs readjustment.

1)Adjust the depth of cut as described above.

2)Set the fine adjuster to zero using the inner ring. Hold the top portion while setting the lower ring to zero.

3)Rotate the fine adjuster to the required position. Graduations are on the top of the fine adjustment knob.

Lock-On/Lock-Off Switch (Fig. 7)

The lock-on/lock-off switch is located in the handle on the right side. The router is normally locked-off.

To start the router, press the thumb lock and squeeze the trigger. To lock the switch on, squeeze the trigger, press the thumb lock forward and release the trigger. To turn the router off, release the switch. If the tool is locked-on, press the trigger again and release the switch.

NOTE: Loosen the plunge limiter and allow the router carriage to return to its rest position before switching off.

FIG. 5

FIG. 6

THUMB LOCK

FIG. 7

3/4	5/8
	1/2

REVOLVER DEPTH

STOP

FINE

ADJUSTMENT

KNOB

0.	0.6

TRIGGER

PRESS TO LOCK ON