Cisco Systems C819HK9, 819G Mounting the DC Power Supply, DC Power Supply Wall-Mounting Features

Chapter 2 Installing the Router

Mounting the DC Power Supply

Mounting the DC Power Supply

Warning Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system. Statement 378

The Cisco 800 ISR DC power supply may be mounted to a wall using four #6 pan- or round-head wood screws for the mounting holes on the supply.

Caution Each mounting screw must go into a wall stud (wood) or a wall anchor of the appropriate type for the wall. Screws into drywall is not sufficient to support the DC power supply.

For attaching to a wall stud, the power supply requires #6 wood screws (round- or pan-head). The screws must be long enough to penetrate and tap at least 0.75 inches (19.1 mm) into the supporting wood or metal wall stud.

For hollow-wall mounting, the power supply requires the use of appropriate-sized wall anchors that work with the drywall thickness the unit is to be installed in. Use hollow-wall anchors that support using #6 screws and use #6 pan- or round-head screws to secure the power supply to the wall. Each wall anchor should be rated for at least 30 lbs.

Caution If the screws are not properly anchored, the strain of the DC supply cables could pull the router from the wall.

Figure 2-16 DC Power Supply Wall-Mounting Features

(3.63)

4X (.48)

(2.95)

2.44

(1.97)

4X .17 2.05

To mount the DC power supply to the wall, follow these instructions:

302465

Step 1 Install the four screws into the mounting holes on the DC power supply (see Figure 2-16) before being secured to the wall studs or wall anchors.

Step 2 Hang the DC power supply by securing the screws to the wall stud or into the wall anchors.

	Cisco 819 Integrated Services Router Hardware Installation Guide
OL-23125-02		2-17