Cisco Systems C819GUK9 Connecting a Modem to the Console Port, Terminal Emulator Settings

Chapter 3 Connecting the Router

Connecting a Modem to the Console Port

Terminal Emulator Settings

Use the following settings for the terminal emulator connection:

•9600 baud

•8 data bits, no parity

•1 stop bit

•No flow control

When the terminal emulator establishes communications, the router prompt is displayed.

For more information on terminal emulation settings, see Applying Correct Terminal Emulator Settings for Console Connections.

Connecting a Modem to the Console Port

To connect a modem to the router, follow these steps:

Step 1 Connect the RJ-45 end of the adapter cable to the Console port on the router as shown in Figure 3-4.

Figure 3-4 Connecting a Modem to the Console Port

1

2

3 4

245587

Step 2 Connect the DB-9 end of the console cable to the DB-9 end of the modem adapter.

Step 3 Connect the DB-25 end of the modem adapter to the modem.

Step 4 Make sure that your modem and the router console port are configured for the same transmission speed (up to 115200 b/s is supported) and support mode control with data carrier detect (DCD) and data terminal ready (DTR).

Cisco 819 Integrated Services Router Hardware Installation Guide

OL-23125-02 3-5