Grizzly G0458 instruction manual Circuit Requirements, 110V Operation

Page 10

SECTION 2: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you connect the machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.

Amperage Draw

The 11⁄2 HP motor on the Model G0458 draws the following amps during normal operation:

Motor Draw

15 Amps

Circuit Requirements

Only connect your machine to a circuit that meets the requirements below. Always check to see if the wires and circuit breaker in your circuit are capable of handling the amperage draw from your machine, as well as any other machines that could be operating on the same circuit. If you are unsure, consult a qualified electrician.

Minimum Circuit Requirement	20 Amp

Figure 1. Typical plug and receptacle.

-8-

Electrocution or fire could result if this machine is not grounded correctly or if your electrical configu- ration does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!

This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a two-pronged outlet! If the plug will not fit the outlet, have the proper outlet installed by a qualified electrician.

Extension Cords

We do not recommend using extension cords, but if you find it absolutely necessary:

•Use at least a 10 gauge cord that does not exceed 50 feet in length!

•The extension cord must also contain a ground wire and plug prong.

•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.

G0458 18" Open End Belt/Drum Sander

Image 10

Contents Open End Drum Sander Page Table of Contents Foreword IntroductionContact Info Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Drum Sanders Circuit Requirements 110V OperationItems Needed for Set Up SET UPSet Up Safety UnpackingInventory Box 1 Figures 1 QtyHardware Recognition Chart Components and Hardware Needed Qty Site ConsiderationsStand To assemble the standPage Installing Sander on Stand To install the sander on the standTilting sander upright G0458 18 Open End Belt/Drum Sander Handwheel To install the handwheelTo install the dust port Dust Port and BagDust Collection Test Run To connect the dust ports to a dust collectorRecommended Adjustments Operations Operation Safety Depth of CutTo set the depth of cut Variable Speed Sanding To adjust the feed belt speedTo sand a workpiece Choosing Sandpaper Sanding TipsGrit Class Usage To change the paper Disconnect power to the sander Paper ReplacementTools Needed Qty Page PRO-STICKSanding Pad AccessoriesG3640-Power Twist V-Belt 1⁄2 x SizeDaily Checks and Maintenance MaintenanceCleaning ScheduleSanding Belts Feed belt drive chainBelt Tensioning Checking V-belt tension with a Straightedge and a rulerService TroubleshootingSanding Operations To replace the V-belts Disconnect power to the sander Replacing V-BeltsFeed Belt Tracking To align the pulleys Disconnect power to the sanderPulley Alignment To track the feed beltFeed Belt Tension To tension the feed beltFeed Belt Replacement To replace the feed belt Disconnect power to the sanderGauge Blocks Table AdjustmentsTo align the drums Disconnect power to the sander To make the gauge blocksPressure Plate Adjustments Plate Adjustment Wiring Diagram G0458 Parts Breakdown G0458 Parts List DescriptionMotor Bracket Chip Deflector Plate Warranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog