Grizzly G0458 instruction manual

9.Wrap the sandpaper around the drum (Figure 21), ensuring there are no bubbles or over- lapping edges.

Figure 21. Wrapping sandpaper around drum.

10.When the sandpaper reaches the right side of the drum, move the sandpaper out of the way with a 4mm wrench and place it into the access hole.

11.Rotate the drum toward you so the wrench rests against the frame as shown in Figure 22.

Access

Hole

Figure 22. Hex wrench inserted into access hole

on right tension wheel.

G0458 18" Open End Belt/Drum Sander

12.Firmly hold down the sandpaper with both hands, rotate the drum toward you, then wrap the end of the sandpaper over the top of the drum (Figure 23).

Figure 23. Wrapping sandpaper over tension

wheel.

13.Place the end of the sandpaper into the clamp, secure it, and remove the hex wrench from the access hole.

14.If the sandpaper does not fit into the right clamp, you may have inserted the sandpaper too deeply into the left clamp. Also, check to make sure the length, width, and angled cuts match the pattern in Figure 19. Make adjust- ments to the sandpaper if necessary.

If sandpaper completely covers the access hole, you may have placed too little sandpa- per into the left clamp. Unwrap the sandpaper and redo Steps 8–13.

15.In either case, reinstall the sandpaper, repeat Steps 9–13, and continue adjusting the paper until it fits into the clamp.

16.When finished, reinstall the chip deflector, secure it with the three cap screws, and close the cover.

-23-