Grizzly G0458 instruction manual Recommended Adjustments

Page 20

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping, some of these adjustments may need to be repeated to ensure optimum results. Keep this in mind as you start to use your new drum sander.

Step-by-step instructions for these adjust- ments can be found in SECTION 7: SERVICE ADJUSTMENTS.

1.V-Belt Tensioning (Page 27). Perform after the first 16 hours.

2.Feed Belt Tensioning & Tracking (Pages 31 & 32).

3.Table Adjustments (Page 34).

-18-	G0458 18" Open End Belt/Drum Sander

Image 20

Contents Open End Drum Sander Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Drum Sanders Circuit Requirements 110V OperationSET UP Set Up SafetyItems Needed for Set Up UnpackingInventory Box 1 Figures 1 QtyHardware Recognition Chart Site Considerations StandComponents and Hardware Needed Qty To assemble the standPage Installing Sander on Stand To install the sander on the standTilting sander upright G0458 18 Open End Belt/Drum Sander To install the handwheel To install the dust portHandwheel Dust Port and BagDust Collection Test Run To connect the dust ports to a dust collectorRecommended Adjustments To set the depth of cut Operation Safety Depth of CutOperations To sand a workpiece To adjust the feed belt speedVariable Speed Sanding Grit Class Usage Sanding TipsChoosing Sandpaper Tools Needed Qty Paper ReplacementTo change the paper Disconnect power to the sander Page Accessories G3640-Power Twist V-Belt 1⁄2 xPRO-STICKSanding Pad SizeMaintenance CleaningDaily Checks and Maintenance ScheduleSanding Belts Feed belt drive chainBelt Tensioning Checking V-belt tension with a Straightedge and a rulerService TroubleshootingSanding Operations To replace the V-belts Disconnect power to the sander Replacing V-BeltsTo align the pulleys Disconnect power to the sander Pulley AlignmentFeed Belt Tracking To track the feed beltFeed Belt Tension To tension the feed beltFeed Belt Replacement To replace the feed belt Disconnect power to the sanderTable Adjustments To align the drums Disconnect power to the sanderGauge Blocks To make the gauge blocksPressure Plate Adjustments Plate Adjustment Wiring Diagram G0458 Parts Breakdown G0458 Parts List DescriptionMotor Bracket Chip Deflector Plate Warranty and Returns Warranty Card CommentsGrizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog