Grizzly instruction manual Tilting sander upright G0458 18 Open End Belt/Drum Sander

Page 17

5.Lay the stand on the blocks as shown in Figure 10.

Figure 10. Stand resting on blocks.

6.Align the holes, and secure the stand to the sander with the remaining hex bolts, wash- ers, and hex nuts (Figure 11).

Note: If the holes do not align, add wood shims to adjust the block heights.

Figure 11. Mounting sander to stand.

7.Lift up on the stand and remove the blocks.

8.Tighten the mounting bolts.

9.Tilt the sander upright, as shown in Figure 12, so the rear legs touch the floor.

If the legs start to slide when tilting, you MUST have a third person hold the stand from sliding to avoid personal injury or machine damage!

Figure 12. Tilting sander upright.

G0458 18" Open End Belt/Drum Sander

-15-

Image 17
Contents Open End Drum Sander Page Table of Contents Contact Info IntroductionForeword Machine Data Sheet Identification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Drum Sanders 110V Operation Circuit RequirementsSet Up Safety SET UPItems Needed for Set Up UnpackingBox 1 Figures 1 Qty InventoryHardware Recognition Chart Stand Site ConsiderationsComponents and Hardware Needed Qty To assemble the standPage To install the sander on the stand Installing Sander on StandTilting sander upright G0458 18 Open End Belt/Drum Sander To install the dust port To install the handwheelHandwheel Dust Port and BagTo connect the dust ports to a dust collector Dust Collection Test RunRecommended Adjustments To set the depth of cut Operation Safety Depth of CutOperations To sand a workpiece To adjust the feed belt speedVariable Speed Sanding Grit Class Usage Sanding TipsChoosing Sandpaper Tools Needed Qty Paper ReplacementTo change the paper Disconnect power to the sander Page G3640-Power Twist V-Belt 1⁄2 x AccessoriesPRO-STICKSanding Pad SizeCleaning MaintenanceDaily Checks and Maintenance ScheduleFeed belt drive chain Sanding BeltsChecking V-belt tension with a Straightedge and a ruler Belt TensioningTroubleshooting ServiceSanding Operations Replacing V-Belts To replace the V-belts Disconnect power to the sanderPulley Alignment To align the pulleys Disconnect power to the sanderFeed Belt Tracking To track the feed beltTo tension the feed belt Feed Belt TensionTo replace the feed belt Disconnect power to the sander Feed Belt ReplacementTo align the drums Disconnect power to the sander Table AdjustmentsGauge Blocks To make the gauge blocksPressure Plate Adjustments Plate Adjustment Wiring Diagram G0458 Parts Breakdown Description G0458 Parts ListMotor Bracket Chip Deflector Plate Warranty and Returns Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog