5.If the table is not 90û from the spindle, adjust the table stop bolt to allow the table to move more as shown in Figure 10.
!
Figure 10. Squaring the sanding table.
6.Tighten the table stop bolt against the under- side of the table when the table is set at 90û.
Squaring Disc
Sander
The sanding tables for the spindle sander and the disc sander have tilting capabilities from 0û to 45û.
To tilt the sanding table:
1.Disconnect the machine from the power sup- ply.
2. Using a machinist square, set one edge on the table surface and the other against the face of the sanding disc as shown in Figure
11.NoteÑThis can be done with the sand- paper installed, although it is somewhat eas- ier to measure if the disc does not have the sandpaper disc installed.
Figure 11. Squaring the sanding table.
3.Loosen the lock lever and adjust the table angle until it is perfectly perpendicular and flush with both edges of the machinist square.
4.Tighten the lock lever while holding the table perpendicular.
5.Adjust the scale pointer to read 0û when the table has been properly adjusted.
G0529 Oscillating Spindle & Disc Sander |