Sanding Disc
Installation
The disc sander requires 12" sanding discs with hook and loop backing.
To install a new sanding disc on the 12" disc sanding surface:
1.Disconnect the machine from the power sup- ply.
2.Remove the disc sanding table.
3.Remove the old sanding disc.
4.Install the new sanding disc as shown in Figure 12.
!
Figure 12. Installing sanding disc.
Aligning Table
The table must be aligned to the face of the sand- ing disc so that the sandpaper does not rub against the table.
To align the table:
1.Loosen the bolts that secure the table to the table support bracket as shown in Figure 13.
!
Figure 13. Loosening table bolts.
2.Align the table so that there is a 1Ú16'' gap between the 12" disc and the table.
3.Tighten the bolts loosened in step 1.
4.Spin the disc by hand to check if the sand- paper is touching the table. NoteÑDO NOT turn the disc sander on at this point.
5.Repeat steps 1-3 if the sandpaper touches table at any point in the rotation.
|
|
|
|
|
|
|
|
|
|
|
|
G0529 Oscillating Spindle & Disc Sander | |||