Grizzly G0529 instruction manual Maintenance Safety, Schedule, Weekly, Long-Term Storage

Page 23

SECTION 7: MAINTENANCE

Maintenance Safety

Your safety is important! Please follow the warnings below during this entire section:

!could occur if you con- nect your machine to theSerious personal injury

power source during the maintenance process. DO NOT connect the machine to the power source while performing any maintenance on this machine.

Schedule

Check for the following conditions before you use the sander:

¥ Loose table bolts.

Worn or damaged sanding discs or sleeves.

Worn or damaged wires.

Any other condition that could hamper the safe operation of this machine.

Perform the following tasks at the scheduled time intervals:

After Each Use

¥Wipe off the sawdust build-up from the table surface.

¥Turn off power switch and remove the switch key.

¥Check for spindle straightness.

Weekly

Wipe a lubricant such as SLIPIT¨ onto the table.

¥All the bearings are permanently lubri- cated and require no further lubrica- tion

Long-Term Storage

¥Keep unpainted surfaces rust free with products such as Boeshield¨ T-9.

 

 

 

 

 

 

 

 

 

 

 

 

G0529 Oscillating Spindle & Disc Sander

-21-

Image 23
Contents Model G0529 Oscillating Spindle Disc SanderPage Table of Contents Safety Instructions For Power Tools SafetyAMP Rating Length¥ Grip the Workpiece with Both Hands Introduction Volt Circuit Requirements110V Operation GroundingExtension Cords Machine Features Description SET UPUnpacking Parts InventoryCircle Working Clearance Clean UpWeight Load Site ConsiderationsTo assemble the cabinet stand Beginning AssemblyCabinet Assembly To mount the sander to the top of the cabinet stand Installing SpindleMounting Sander To square the sanding tables Table InsertsSquaring Table To tilt the sanding table Squaring Disc SanderTo align the table Sanding Disc InstallationAligning Table Dust Collection To adjust miter gaugeMiter Gauge General Power SwitchTo operate the power switch OperationsPiece Against the Sanding Sleeve Spindle SandingTo perform spindle sanding operations To perform miter sanding operations Miter SandingWeekly MaintenanceMaintenance Safety ScheduleDate Approximate Hours Of Use Maintenance Performed Maintenance LogSize Model Aftermarket AccessoriesReference Info Machine Data Sheet Parts Diagrams & Lists 108 116 106 125 126 143 140 142 137 Description Flat Washer 1Ú4 Troubleshooting Warranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog