Grizzly G0518 instruction manual Sanding Drum, To attach the sanding drum to the arbor

Page 19

Sanding Drum

Slide the arbor wrench over the “flat” on the arbor when loosening or tightening the arbor nuts. Figure 11 shows the location of the arbor “flat.”

Figure 11. One side of the arbor “flat.”

To attach the sanding drum to the arbor:

1.Slide the sanding drum onto the left-side arbor. Note–Make sure the air valve on the sanding drum faces away from the motor.

2.Begin threading the right-hand threaded arbor nut onto the end of the arbor.

3.Using the two arbor wrenches, tighten the arbor nut to secure the sanding drum onto the arbor as shown in Figure 12.

!

Arbor Nut

Figure 12. Tightening the sanding

drum arbor nut.

G0518 Drum / Flap Sander

4.Slide the sanding sleeve over the sanding drum as shown in Figure 13. If there is a directional arrow printed on the inside of an aftermarket sanding sleeve, make sure it matches the rotation direction label on the motor. Note–The Model G0518 uses 4"D x 9"W sanding sleeves. The Grizzly Catalog offers a wide range of available grits to suite just about any sanding operation.

!

Rotational

Direction

Label

Figure 13. Sliding the sanding sleeve

over the sanding drum.

5.Using a hand-operated bicycle tire pump, carefully inflate the sanding drum (Figure 14) to a pressure no greater than 10 PSI.

!

Figure 14. Inflating the sanding drum.

-17-

Image 19
Contents Drum / Flap Sander Page Table of Contents Safety Instructions For Power Tools SafetyLength Keep Fingertips Away from MOV- ING Parts Safety Instructions For Drum / Flap SandersCommentary Introduction110V Operation Circuit RequirementsNema 6-15 plug and grounded outlet 220V OperationExtension Cord GroundingFront view of sander G0518 Drum / Flap Sander Machine FeaturesUnpacking Piece Inventory SET UPBox 2 Qty Box 1 QtyBox 3 Qty Stand Base Hardware Recognition Chart Working Clearance Clean UpWeight Load Site ConsiderationsStand To Base Beginning AssemblyTo attach the stand to the base Dust Hood Brackets Motor To StandTo attach the dust hood brackets to the stand To attach the acrylic eye shields to the dust hoods Dust HoodsAcrylic Eye Shields To attach the dust hoods to the bracketsTo attach the sanding drum to the arbor Sanding DrumTo attach the flap sander to the arbor Flap SanderTo attach dust collection hoses to the dust hoods Dust CollectionStart Up Operation Operation Safety Choosing SandpaperGrit Type Checking air pressure Drum SandingFlap Sanding Correctly installed flap sanderMaintenance Safety General MaintenanceBefore each use, perform the following checks To replace the sandpaper flaps Service AdjustmentsChanging Motor Voltage Reference Info Machine Data Sheet Parts Diagrams and Lists Description G0518 Drum / Flap Sander Motor Shaft Dia. Aluminum Oxide Sandpaper Rolls 60, J Weight, Aluminum OxideSandpaper Cleaning Sticks Dust Collection AccessoriesWarranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCCall Today For a Free Full Color Catalog