Grizzly G0518 instruction manual Circuit Requirements, 110V Operation

Page 8

SECTION 3: CIRCUIT REQUIREMENTS

110V Operation

Amperage Draw

The Model G0518 is prewired to operate at 110V, with an amperage draw of approximately 12A.

Plug Type

The Model G0518 is supplied with a NEMA 5-15 plug. DO NOT modify the plug or power cord in any way. See Figure 1 for a NEMA 5-15 plug and grounded outlet.

Figure 1. NEMA 5-15 plug and grounded outlet.

Circuit Breaker Requirements

We recommend operating the machine on a ded- icated circuit. Because the machine draws 12A when operated at 110V, use a 15A circuit break- er. Circuit breakers rated any higher are not ade- quate to protect the circuit from overheating and fire.

Your Circuit Capacity

Always check to see if the wires in your circuit are capable of handling the amperage draw from your machine, as well as any other machines that could be operating on the same circuit. If you are unsure, consult a qualified electrician.

If the circuit breaker trips or the fuse blows regu- larly, your machine may be operating on a circuit that is close to its amperage draw capacity. However, if an unusual amperage draw does not exist and a power failure still occurs, contact a qualified electrician or our service department.

Serious personal injury could occur if you connect your machine to the power source before you have completed the assembly process. DO NOT connect the machine to the power source until instructed to do so.

 

 

 

 

 

 

 

 

 

 

 

 

-6-

 

G0518 Drum / Flap Sander

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Drum / Flap Sander Page Table of Contents Safety Safety Instructions For Power ToolsLength Safety Instructions For Drum / Flap Sanders Keep Fingertips Away from MOV- ING PartsIntroduction CommentaryCircuit Requirements 110V Operation220V Operation Nema 6-15 plug and grounded outletGrounding Extension CordMachine Features Front view of sander G0518 Drum / Flap SanderSET UP Unpacking Piece InventoryBox 3 Qty Stand Base Box 1 QtyBox 2 Qty Hardware Recognition Chart Clean Up Weight LoadSite Considerations Working ClearanceTo attach the stand to the base Beginning AssemblyStand To Base To attach the dust hood brackets to the stand Motor To StandDust Hood Brackets Dust Hoods Acrylic Eye ShieldsTo attach the dust hoods to the brackets To attach the acrylic eye shields to the dust hoodsSanding Drum To attach the sanding drum to the arborFlap Sander To attach the flap sander to the arborDust Collection To attach dust collection hoses to the dust hoodsStart Up Grit Type Operation Safety Choosing SandpaperOperation Drum Sanding Checking air pressureCorrectly installed flap sander Flap SandingBefore each use, perform the following checks MaintenanceMaintenance Safety General Service Adjustments To replace the sandpaper flapsChanging Motor Voltage Reference Info Machine Data Sheet Parts Diagrams and Lists Description G0518 Drum / Flap Sander Motor Shaft Sandpaper Rolls 60, J Weight, Aluminum Oxide Sandpaper Cleaning SticksDust Collection Accessories Dia. Aluminum OxideWarranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WACall Today For a Free Full Color Catalog
Top Page Image Contents