Sanding Belt
To install the sanding belt:
1.Disconnect the sander from the power source!
2.
Figure 9. Roller tension switch.
3.Remove the lock handle bolt (Figure 10) by turning it counter-clockwise 1⁄2 a turn and pulling it up and out of the mounting hole.
Lock Handle Bolt
Spacer Block
Figure 10. Components used when changing a
sanding belt.
4.Remove the spacer block (Figure 10).
5.Install the sanding belt by starting first on the upper roller and then the lower roller. Note— The sanding belt must be centered between the limit switches. If either edge of the sand- ing belt is touching either limit switch, turn the belt tension switch off and adjust the belt until it is properly centered as shown in Figure 11.
Limit Switches |
Sanding Belt |
Sander Outline |
(Top View) |
Figure 11. Proper position of belt between the
limit switches.
NOTICE
The directional arrow on the back of the sanding belt must be pointing in a counter- clockwise direction when installing it. Failure to install the sanding belt correctly could result in damage to the sanding belt or the sander itself.
6.Replace the spacer block and tighten down the lock handle bolt.
7.With your hands clear of all moving parts, tension the belt.
G0527 18" Wide Belt Sander |