Grizzly G0527 Table Movement Adjusting Feed Rate, Controls for adjusting Table height

Page 23

Table Movement

 

Adjusting Feed Rate

 

 

 

 

 

 

The table height can be adjusted either manually or by power assist.

Manual Adjustment—Manual adjustments are made by turning the handwheel located under the front of the infeed table. The thickness measure- ment is displayed on the digital readout.

Power Assist—Press the TABLE UP or TABLE DOWN key on the control panel shown in Figure 12. The digital display reading changes as the table moves up and down.

23 0

5 6

8 9

Figure 12. Controls for adjusting

the table height.

NOTICE

The thickness gauge is pre-calibrated from the factory; however, correct calibration should be verified by using the instructions on page 27.

The feed belt motor and gear assembly (Figure 13) controls the speed of the feed belt. The Model G0527 features feed belt speeds of 16.4, 23, and 32.8 FPM.

32.8

16.4

23

Figure 13. Table drive chain and sprockets.

To change feed belt speed:

1.Disconnect the sander from the power source!

2.Remove the cap screw that secures the feed belt motor cover.

3.Loosen the motor mount bolts so that the motor will slide up enough to get the chain off the sprockets.

4.Determine which speed is best for your appli- cation and place the chain accordingly.

5. Tighten the motor mount bolts loosened in step 3.

6.Replace the motor cover and secure it with the cap screw removed in step 2.

G0527 18" Wide Belt Sander

-21-

Image 23
Contents Wide Belt Sander Page Table Of Contents Safety Instructions For Power Tools SafetyLength Additional Safety For Wide Belt Sanders Commentary IntroductionConnection Type Circuit RequirementsAmperage Draw Circuit BreakerGrounding Minimum Cord Size Extension CordsExternal Features Machine FeaturesControl Panel Access Doors Page Following parts shown in should be enclosed SET UPG0527 Inventory Bolt Measure Hardware Recognition ChartWork Area Lightening Clean Up Site ConsiderationsWorking Clearance Beginning Assembly Floor Mounting To hook up the dust collection system Air Line Hook-Up Dust CollectionTo hook up the air line Sanding Belt Proper position of belt between Limit switchesPressure Rollers Recommended adjustment checklist Recommended AdjustmentsGrit OperationsBefore Sanding Choosing SandpaperControls for adjusting Table height Table Movement Adjusting Feed RateNormal Operating Load Amperage Meter Sanding WorkpieceGeneralSchedule MaintenanceServicing Brakes Air Circuit Filters Clean Sanding Belts Date Approximate Hours Of Use Maintenance Performed Maintenance LogCalibration Service AdjustmentsFeed Belt Tracking Feed Belt TensionTo check the sanding belt oscillation Belt OscillationTable Parallelism To adjust the table parallelismPressure Rollers Periodically inspect the following Belt AdjustmentAir System Air Line Circuit Date Approximate Hours Of Use Service Performed Service LogGeneral Aftermarket AccessoriesCleaning Pads Reference InfoMachine Data Sheet Description Parts Diagrams & Lists1305 1308 Machine Frame 2101 2202 2103 Elevation Screw 3132 Conveyor Table Spring Ball Bearing UCC206 Page Square Frame Machine ID Label Page Electrical Control BOX Page Filter CUP 1⁄4 Symptom Possible Cause Corrective Action Machine TroubleshootingTion Sanding TroubleshootingPage Page G0527 18 Wide Belt Sander Warranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage #ALL 4ODAYD&ORO