Grizzly G0527 instruction manual Recommended Adjustments, Recommended adjustment checklist

Page 21

Starting the machine:

1.Wear safety glasses at all times when run- ning the machine!

2.Connect the machine to the power source.

3.Press the TABLE UP and TABLE DOWN keys. The table should go up and down smoothly.

4.Press the FEED BELT START and FEED BELT STOP buttons. The feed belt should start, run and stop smoothly.

5.Press the SANDING BELT START and SANDING BELT STOP buttons. The sanding belt should start, run and stop smoothly.

The machine should run smoothly, with little or no vibration or rubbing noises. Strange or unnatural noises should be investigated and corrected before operating the machine further.

If the machine seems to be running correctly, let it run for a short time to ensure that the moving parts are working properly with no excessive vibration. DO NOT operate the machine if prob- lems cannot be corrected.

If you cannot locate the source of unusual noises, feel free to contact our Service Department at (570) 546-9663.

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and require no further adjustment. However, because of the many variables involved with shipping, we recommend that you read through Section 8: Service Adjustments on page 27 and verify that the adjustments are correct.

Recommended adjustment checklist:

•Calibration

•Feed Belt Tension

•Feed Belt Tracking

•Oscillation Timing

•Oscillation Speed

•Pressure Rollers

•Table Parallelism

•V-Belt Adjustment

•Air System

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

G0527 18" Wide Belt Sander

-19-

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Wide Belt Sander Page Table Of Contents Safety Instructions For Power Tools SafetyLength Additional Safety For Wide Belt Sanders Commentary IntroductionAmperage Draw Circuit RequirementsCircuit Breaker Connection TypeGrounding Minimum Cord Size Extension CordsExternal Features Machine FeaturesControl Panel Access Doors Page SET UP G0527 InventoryFollowing parts shown in should be enclosed Bolt Measure Hardware Recognition ChartClean Up Site Considerations Working ClearanceWork Area Lightening Beginning Assembly Floor Mounting Air Line Hook-Up Dust Collection To hook up the air lineTo hook up the dust collection system Sanding Belt Proper position of belt between Limit switchesPressure Rollers Recommended adjustment checklist Recommended AdjustmentsBefore Sanding OperationsChoosing Sandpaper GritControls for adjusting Table height Table Movement Adjusting Feed RateNormal Operating Load Amperage Meter Sanding WorkpieceGeneralSchedule MaintenanceServicing Brakes Air Circuit Filters Clean Sanding Belts Date Approximate Hours Of Use Maintenance Performed Maintenance LogCalibration Service AdjustmentsFeed Belt Tracking Feed Belt TensionTo check the sanding belt oscillation Belt OscillationTable Parallelism To adjust the table parallelismPressure Rollers Belt Adjustment Air SystemPeriodically inspect the following Air Line Circuit Date Approximate Hours Of Use Service Performed Service LogCleaning Pads Aftermarket AccessoriesReference Info GeneralMachine Data Sheet Description Parts Diagrams & Lists1305 1308 Machine Frame 2101 2202 2103 Elevation Screw 3132 Conveyor Table Spring Ball Bearing UCC206 Page Square Frame Machine ID Label Page Electrical Control BOX Page Filter CUP 1⁄4 Symptom Possible Cause Corrective Action Machine TroubleshootingTion Sanding TroubleshootingPage Page G0527 18 Wide Belt Sander Warranty & Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage #ALL 4ODAYD&ORO
Top Page Image Contents