Kenmore 808353 manual 4tfi Rinse, Dry, Water Heat Option Hot Rinse, Wash, SanM4/ash Delay Circuit

WATER TEMPERATURE

OPERATING CHARACTERISTICS

iNLET WATER TEMR-140°F

W

z

	!1		nlll
1stWASH	]st RtNSE 2naRIN	WASH	3rd RIN	4tfi RINSE		DRY
	FIGURE62		Water	Heat	Option
			Hot	Rinse	Option

In Figure 62, inlel water temperature is at 140 degrees constant Operation with t40 degree inlet water tempera-

lure, is adequate and will do a good job of washing dishes Notice how water heat and ho_ rinse options will function with 140 ° inlet temperature

C SanM4/ash Delay Circuit

Figure 63A shows the circuit at the fourth rinse when the Sent-Wash cycle has been selected and the water tem- perature is below the indicated Sani temperature [}50 degrees) The swilch to the timer motor has opened; therefore, the timer cannol advance The temperature delay light wiiJ be energized through the Sani-Wash switch and the coil of the motor (Current flow through the coils will be insufficient to cause the motor to run )

During this delay period, the water continues td circulate and rinse the dishes while the heating element gradually raises the temperature of the water When the "Sani" temperature is reached, the double throw thermostat

closes its contact one to two, the delay light goes out, the "sent" indicator light glows, and the timer motor is energized through contact 1 and 2 of the thermostat for one minute, after which the timer motor switch again closes The timer motor remains energized for the remainder of the rinse and dry cycle

For models without temperature indicator _ights, the sani delay function operates in the same manner, however, the thermostat is a single pole, single throw switch

54