Sanyo Sanyo Split System Air Conditoner Operation with the Remote Control Unit, Manual fan speed

OPERATION WITH THE REMOTE CONTROL UNIT

1. Operation

STEP 2

STEP 1

STEP 3

STEP 5

STEP 4

NOTE	Check that the circuit breaker on the power panel is
		turned on.
		Press the setting buttons as described below and
		change the settings as desired.
		STEP 1 Press the MODE selector button and
		select the desired mode.
		For cooling operation	→
		For dehumidifying operation →
		For fan only operation	→
		STEP 2 To start the air conditioner, press the ON/
		OFF operation button.
		STEP 3 Press the TEMP. setting buttons to
		change the temperature setting to the
		desired temperature. The set temperature
		appears in the display for only 3 seconds.
		Adjustable temperature range:

30°C max.

16°C min.

STEP 4 Set the FAN SPEED selector button to the setting you want.

STEP 5 Press the FLAP button and set the airflow direction as desired.

(Refer to “ADJUSTING THE AIRFLOW DIRECTION” on page 13.)

To stop the air conditioner, press the ON/OFF operation button again.

NOTE • Choose the best position in the room for the remote control unit, which also transmits the operating instructions. Once you’ve found this best position, always keep the remote control unit there.

•This appliance has a built-in 5-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop.

2. Adjusting the Fan Speed

A. Automatic fan speed

Simply set the FAN SPEED selector button to the position.

This automatically sets the best fan speed for the room temperature.

B. Manual fan speed

If you want to adjust fan speed manually during operation, just set the FAN SPEED selector button as desired. [ , , or ]

3. Fan Only

STEP 2

STEP 1

STEP 3

If you want to circulate air without any temperature control, follow these steps:

STEP 1	Press the MODE selector button to switch
	to the fan mode	.
STEP 2	Press the ON/OFF operation button.

STEP 3 Press the FAN SPEED selector button to select the fan speed of your choice ( , or ).

OI-018-9-EG 9