ADJUSTING THE AIRFLOW DIRECTION 
1. Horizontal
The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or right. Always use the knobs located at the top of the center vanes on the left and right sides to adjust the airflow direction.
Knob
CAUTION
When the humidity is high, the vertical vanes should be in the front position during the cooling or dehumidifying operation. If the vertical vanes are positioned all of the way to the right or left, condensation may begin to form around the air vent and drip down.
2. Vertical
The vertical airflow can be adjusted by moving the flap with the remote control unit. Do not move the flap with your hands. Confirm that the remote control unit has been turned on. Use the FLAP button to set either the sweep function or one of the six airflow direction settings.
SWEEP
COOL
DRYSWEEP
FAN
A. Sweep function
The flap starts moving up and down to deliver air over the sweep range.
B. Setting the airflow manually
Referring to the above illustration, use the FLAP button to set the airflow direction within the range used during the cooling or dehumidifying operation.
C. Auto flap function
The flap is set to the recommended position.
NOTE
• The flap automatically closes when the unit is off.
CAUTION
•Use the FLAP button on the remote control to adjust the position of the flap. If you move the flap by hand, the flap position according to the remote control and the actual flap position may no longer match. If this should happen, shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.
•Do not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.
OPERATION WITHOUT THE REMOTE CONTROL UNIT 
INDOOR UNIT
OPERATION
TIMER
OPERATION
ON/OFF
button (ON/OFF)
If you have lost the remote control unit or it has trouble, follow the steps below.
When the air conditioner is not running
Each time the OPERATION button is pressed, the operation mode changes cyclically.
Cooling |
| Stop |
operation |
| |
|
|
13 | |
|