Black & Decker ET 1490, ET 1480, 388072 Spindle Lock Button, Attaching and Removing Polishing Pads

English

			lower speed settings (2600 RPM and below), than at high speeds.
			As the tool approaches 3000 RPM, the effect is considerably less
FIG. 4	CLAMP	FIG. 5	dramatic.
			Keep in mind that, with a conventional polisher running at a typical no
	WASHER	POLISHING BONNET
			load speed of 2400 RPM, the tool slows down to about 2000 RPM
POLISHING BONNET			under a polishing load. Your ET1490 will continue to run at 2400 RPM
			(or any speed you select with the control wheel) as a load is applied.
			Since it doesn’t slow down, the speed may be greater than you’re
			used to so some extra caution should be observed until you get the
			“feel” of your polisher. If you feel the speed is too great, you can, of
			course slow the tool down with either the trigger switch or the control
			wheel.
BACKING PAD			Spindle Lock Button
			TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
			(See Figure 1) In order to prevent the spindle of the tool from rotating
			while installing or removing accessories, a spindle lock button has
			been provided in the gear head of the machine. To lock the spindle,
	SPINDLE		depress and hold the lock button. NEVER DEPRESS THE SPINDLE
			LOCK BUTTON WITH THE TOOL RUNNING OR COASTING.
			Attaching and Removing Polishing Pads
			(FIGURES 4 & 5)
			TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
			To attach pad, push the hub of the clamp washer through the hole in
			the center of the polishing pad as far as it will go. Engage the
			hexagonal hole in the backing pad. Holding the three pieces firmly
			together, place the assembly on the tool spindle. Hold the spindle
			lock button while turning the pads clockwise to thread them
			completely on the spindle.
			To remove the pads, turn them by hand in the opposite direction from
			normal rotation to allow lock button to engage spindle, then unscrew
			pads in normal direction for right hand thread.

4