Schumacher 94070A, 98026071, 00-99-000985 manual Introduction Description, Welder Performance

•ANSI Standard Z87.1 — SAFE PRACTICE FOR OCCUPATION AND

EDUCATIONAL EYE AND FACE PROTECTION — obtainable from the American National Standards Institute, 11 West 42nd St., New York, NY

10036 Telephone (212) 642-4900, Fax (212) 398-0023 - www.ansi.org

•NFPA Standard 51B — CUTTING AND WELDING PROCESS — obtainable from the National Fire Protection Association, 1 Batterymarch

Park, P.O. Box 9101, Quincy, MA 02269-9101 Telephone (617) 770-3000, Fax (617) 770-0700 - www.nfpa.org

•OSHA Standard 29 CFR, Part 1910, Subpart Q., WELDING, CUTTING

AND BRAZING — obtainable from your state OSHA office or U. S. Dept. of Labor OSHA, Office of Public Affairs, Room N3647, 200 Constitution

Ave. NW Washhington, DC 20210 - www.osha.gov

•CSA Standard W117.2 — Code for SAFETY IN WELDING AND CUTTING. — obtainable from Canadian Standards Association, 178

Rexdale Blvd. Etobicoke, Ontario M9W 1R3 - www.csa.ca

•American Welding Society Standard A6.0. WELDING AND CUTTING CONTAINERS WHICH HAVE HELD COMBUSTIBLES. — obtainable from the American Welding Society, 550 NW Le Jeune Road, Miami, FL

33126 Telephone (800) 443-9353, Fax (305) 443-7559 - www.amweld.org or www.aws.org

2.INTRODUCTION

2.1DESCRIPTION

Your new welder is designed for general repair, maintenance, and metal fabrication. The welder consists of a single-phase power transformer, and control switch. This welder is capable of welding with 1/16”, 5/64”, and 3/32” general purpose mild steel electrodes.

Now you can weld 18-gauge steel sheet metal up to 1/8” with a single pass. Welds thicker metal with beveling and multiple passes.

2.2WELDER PERFORMANCE

Your welder has been designed to weld on steel from approximately

18 gauge up to 1/8” thick. Thinner and thicker material can be welded depending on the experience and technique of the welder and the type of welding rod being used.

• 6 •