Schumacher SC-8020A owner manual Digital Display Button, Battery Type Button, Battery Size Button

Page 11

12.1DIGITAL DISPLAY BUTTON

Use this button to set the function of the digital display to one of the follow- ing:

BATTERY %: The digital display shows an estimate of the percent of charge of the battery connected to the charger battery clamps.

VOLTAGE: The digital display shows the voltage at the charger battery clamps in DC volts.

ALTERNATOR %: The digital display shows an estimated percentage of the output of the vehicle charging system connected to the charger bat- tery clamps as compared to a properly functioning system.

12.2BATTERY TYPE BUTTON

Use this button to set the type of battery to be charged to one of the fol- lowing.

12V STANDARD: This is the type of battery usually used in cars, trucks, and motorcycles. These batteries have vent caps and are often marked “low maintenance” or “maintenance-free.”

12V AGM: AGM batteries have sealed cases without vent caps. Such batteries come in a wide variety of sizes.

12V GEL CELL: Gel Cell batteries have sealed cases without vent caps. Such batteries are often smaller than the other types.

Batteries should be marked with their type. If charging a battery that is not marked, check the manual of the item that uses the battery. If the battery type is unknown, use the 12V agm setting. Make sure the battery com- plies with the safety instructions in section 2.

12.3BATTERY SIZE BUTTON

Use this button to set the maximum charge rate to one of the following:

SMALL BATTERY: Provides a charge rate of up to 2A. Intended for charging small batteries such as those commonly used in garden trac- tors, snow mobiles and motorcycles. The 2A rate is not intended to be used as a trickle charger for larger batteries.

MEDIUM TO LARGE BATTERY: Automatically switches between 10 and

20 amps, or provides 10 amps continuous depending on the battery. Use for charging medium to large capacity batteries. Not intended for indus- trial applications.

ENGINE START: Provides 80 amps for cranking an engine with a weak or run down battery. Always use in combination with a battery.

OFF: Charger returns to tester mode and the SMALL BATTERY, ME- DIUM TO LARGE BATTERY, and ENGINE START LEDs all stay off.

9

Image 11
Contents M p 1020 Table of contents Important Safety Instructions Preparing to Charge Personal PrecautionsCharger Location DC Connection PrecautionsBattery charging ac connections AC input rating Using engine start Assembly instructionsOperating instructions Engine Starting NotesCharger controls Completion of ChargingGeneral Charging Notes Digital Display Button Battery Type ButtonBattery Size Button Control panel guide SC-8020A Control pANEL gUiDETester and Charger Testing SequencePOWER-UP Idle Time Limit Testing After ChargingInitial Percent Calculation Using the built-in alternator testerBattery percent and charge time Alternator Testing NotesCharging tips Maintenance Instructions Problem Possible Cause Solution TroubleshootingPage Page Manual DEL Dueño Indice DEL Contenido Page PREPARación de la carga Precauciones PersonalesPrecauciones DE LA Conexión CC Ubicación DEL CargadorSiga Estos Pasos cuando la batería esté afuera del vehículo Bateria Cargando Conexiones AC USO DEL Arranque DEL Motor Instrucciones DE EnsambladoFinalización DE LA Carga Instrucciones OperativasNotas Generales Sobre LA Carga Digital Display Button Botón DE Visor Digital Battery Type Button Botón DE Tipo DE BateríaControles DEL Cargador Medium to Large Battery Baterías Medias a Grandes Battery Size Button Botón DE Tamaño DE LA BateríaGUiA DE Control DEL Tablero DE Mandos pARA Modelo SC-8020A Guia DE Control DEL Tablero DE MandosProbador SIN Límite DE Tiempo Secuencia DE PruebaProbador Y Cargador 14.3 Límite DE Tiempo DE Inactividad Durante EL EncendidoUTILIZACIÓN DEL Probador DE Alternadores Incorpo LOS LED DE Estado DEL Probador14.7 Cálculo DEL Porcentaje Inicial Notas Para Probar EL % DE LA BateríaPorcentaje DE LA Batería Y Tiempo DE Carga Notas Sobre LA Prueba DEL AlternadorPage Instrucciones DE Mantenimiento Datos Útiles Sobre LA CargaProblema Causa Posible Solucion Localización y resolución de problemas