Positioning for adjusting the bevel angle |
|
|
The saw blade tilts up to 45" to the left |
|
|
and right. To adjust the bevel angle, loosen |
|
|
the lever a t the rear of the tool. |
|
|
For left bevel cutting, tilt the saw blade to |
|
|
the left until the pointer points to the de- |
|
|
sired angle. Then tighten the lever firmly to |
|
|
secure the arm. |
|
|
For right bevel cutting, press the release |
|
|
button after tilting the saw blade slightly to |
|
|
the left. While pressing the release button, |
|
|
tilt the saw blade to the right until the |
|
|
pointer points to the desired angle. Then | Tighten | |
tighten the lever firmly to secure the arm. |
L
CAUTION :
*When tilting the saw blade, be sure to raise the handle fully.
*After changing the bevel angle, always secure the arm by tightening the lever.
*When changing bevel angles, be sure to position the kerf boards appropriately as explained in the "Positioning kerf boards" section.
11