Install the outer flange and hex bolt, and | I | cover | |
then use the socket wrench to tighten the |
|
|
|
hex bolt securely by turning it counter- |
|
|
|
clockwise while pressing the shaft lock. |
|
|
|
Return the safety cover and the center |
|
|
|
cover to the original position. Then tighten |
|
|
|
the hex bolt to secure the center cover. |
|
|
|
Lower the handle to make sure that the |
|
|
|
safety cover moves properly. |
|
|
|
I
CAUTION:
Use only the Makita socket wrench provided to install or remove the blade. Failure to do so may result in overtightening or insufficient tightening of the hex bolt. This could cause serious injury to operator or others in the general vicinity of the tool.
Safety cover | - - |
When lowering the handle, the safety cover | |
rises automatically. The cover returns to i t s |
|
original position when the cut is complet d |
|
and the handle is raised. NEVER DEFE&T |
|
OR REMOVE THE SAFETY COVER. In |
|
the interest of your personal safety, always |
|
maintain the safety cover in good condition. |
|
Any irregular operation of the safety cover |
|
should be corrected immediately. NEVER |
|
USE THE TOOL WITH A FAULTY |
|
SAFETY COVER. If the |
|
cover becomes dirty, or sawdust adheres to |
|
it in sucha way that the blade and/or work- | ~~ |
piece is no longer easily visible, unplug the saw and clean the cover carefully with a damp cloth. Do not use solvents or any
Dust bag
To attach the dust bag, fit it into the elbow. When the dust bag is about half full, re- move the dust bag from the tool and pull the fastener out. Empty the dust bag by tapping it lightly to remove as much dust as possible.
NOTE :
If you connect a vacuum cleaner to your saw, more efficient and cleaner operations can be performed.
8