When cutting crown and cove moldings, set the bevel angle and miter angle as indicated in the table (A) and position the moldings on the top surface of the saw base as indi- cated in the table (B).
|
|
| Table (AI |
|
|
Molding position | Bevel angle | Miter angle | |||
| I 45O type |
|
| ||
in Fig. (AI |
| 52/38O type |
|
| |
|
|
|
| ||
For inside corner | 0 |
|
|
|
|
__ |
|
|
|
| |
| 0 | 33.90 | 30° | Left 31.6O | Left 35.3" |
| 0 | ||||
For outside corner |
|
|
|
| |
- |
|
| Right 31.6O | 1 Right 35.3" | |
| @I |
| |||
Molding
in Fig. (AI
For inside corner
0
m-
For outside corner
a
Molding edge against guide fence
Ceiling contact edge should be against guide fence.
Wall contact edge should be against guide fence.
Ceiling contact edge should be against guide fence.