2) Bevel angle
i)0" bevel angle
Push the carriage toward the guide fence and tighten the clamp screw on the arm. Loosen the lever a t the rear of the tool. Turn the hex bolt (A) on the turn base two or three revolutions counterclockwise to tilt the blade to the right.
Lower the handle fully and carefully square the side of the blade with top surface of the turn base using the tri- angular rule,
Make sure that the pointer on the arm points to 0" on the bevel scale on the arm holder. If it does not point to O", loosen the screw which secures the pointer and adjust it so that it will point to 0".
2 3