Makita LSl21l instruction manual Makita Limited ONE Year Warranty

Page 30

r1

MAKITA LIMITED ONE YEAR WARRANTY

Warranty Policy .

i v r r y Mnkita tool is t h o r o u e inspected and tested before leaving the factory. It is warranted t o be rrre ol delccts from wor anshrp and materials for the period of ONE YEAR from the date of original purchase. Should any trouble develop during this one-year period, return the COMPLETE tool, freight prepaid. t o one of Makita’s Factory or Authorized Service Centers. If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or a t our option. replace) without charge.

This Warranty does not apply where:

repairs have been made or attemvted by others:

repairs are required because of normal wear and tear:

T h e tool has been abused, misused or improperly maintained; alterations have been made to the tool.

IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY INDIRECT, INCIDENTAL OR CON- SEQUENTIAL DAMAGES FROM THE SALE OR USE OF THE PRODU(JT. THIS DISCLAIMER APPLIES BOTH DURING AND AFTER THE TERM O F THIS WARRANTY.

MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED WARRANTIES, INCLUDING IMPLIED WARRANTIES O F “MERCHANTABILITY” AND “FITNESS FOR A SPECIFIC PURPOSE,” AFTER THEONE - YEAR TERM OF THIS WARRANTY.

This Warranty gives you specific legal rights. and you may also have other rights which vary from state t o state. Some state? do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply t o you. Some states d o not allow limitation on how long an implied warranty lasts, so the above limitation may not apply l o you.

Makita Corporation of America

2650 Gainesville Hwy., Buford, GA 30518

MCA - 3/94

b

PRINTED IN U.S.A.

883860465

 

 

1994-3-C

Image 30
Contents Slide Compound Saw Specifications Manual Before Operating Slide Compound Saw Minimumgauge for Cord Sets Additional Safety Rules Screw on the motor housing Installing or removing saw blade USE the Tool with a Faulty Kerf board Left bevel cut Straight cut Right bevel cut Turn base Tighten the lever firmly to secure the arm Holder w H k r assembly Holder assembly Back position. Secure the workpiece Holder assembly Optional accessory Page Cutting crown and cove moldings Table AI 14-15116 I4 1 5 / 1 KAdjusting screw Stopper arm Page Maintenance Bevel angle On the arm. If the pointer does not Brush holder caps Optional Accessories 305 mm 12 Page 19 1naurlng Makita Limited ONE Year Warranty