Makita LSl21l instruction manual Kerf board Left bevel cut Straight cut Right bevel cut

Page 9

Positioning kerf boards

This tool is provided with kerf boards in the turn base. The kerf boards are factory-adjusted so that the saw blade does not contact the kerf boards. Before use, adjust the kerf boards as follows:

First unplug the tool. Loosen the all screws (2 each on left and right) which secure the kerf boards. Retighten them t o the extent that the kerf boards can be easily moved by hand. Loosen the clamp screw on the arm. Pull the carriage toward you fully and lower the handle fully. Adjust the kerf boards so that the kerf boards just contact the sides of blade teeth slightly. Tighten the front screws (do not tighten firmly). Push the carriage toward the guide fence fully and adjust the kerf boards so that the

kerf boards just contact the sides of blade teeth slightly. Tighten the rear screws (do not

tighten firmly). After adjusting the kerf boards, tighten the a l l screws securely.

1

Kerf board

Left bevel cut

Straight cut

Right bevel cut

CAUTION:

After changing the bevel angle, always readjust the kerf boards as described above.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Slide Compound Saw Specifications Manual Before Operating Slide Compound Saw Minimumgauge for Cord Sets Additional Safety Rules Screw on the motor housing Installing or removing saw blade USE the Tool with a Faulty Kerf board Left bevel cut Straight cut Right bevel cut Turn base Tighten the lever firmly to secure the arm Holder w H k r assembly Holder assembly Back position. Secure the workpiece Holder assembly Optional accessory Page Cutting crown and cove moldings Table AI 14-15116 I4 1 5 / 1 KAdjusting screw Stopper arm Page Maintenance Bevel angle On the arm. If the pointer does not Brush holder caps Optional Accessories 305 mm 12 Page 19 1naurlng Makita Limited ONE Year Warranty
Top Page Image Contents