BM 1619929800
BATTERY CHARGED CONDITION
INDICATOR
The battery is equipped with a charged condition indicator (Fig. 10).
GREEN | FIG. 10 |
INDICATOR LIGHTS |
|
|
|
|
|
| |
|
|
|
| |
|
| RED | ||
BUTTON | ||||
INDICATOR LIGHT | ||||
|
| |||
By pressing the button ON, the charged condition can be checked when the battery is removed or when the machine is not in use. After approx. 5 seconds, the charged indicator switches off automatically.
•• • When all three lights are illuminated, this indicates the battery pack is between 67% and 100% charged.
•• When only two lights illuminate, this indicates the battery pack is between 33% and 66% charged.
•When only one light illuminates, this indicates the battery pack is less than 33% charged.
When one light blinks the battery pack is almost fully discharged.
TEMPERATURE INDICATOR LIGHT
The red indicator light signals whether the battery or tool (with battery inserted) is in the optimum temperature range. When the temperature is too high, the tool will not operate at full capacity.
If the red indicator light illuminates continuously when the battery is inserted into the charger. The battery is outside the charging temperature range and cannot be charged.
If the red indicator light blinks when the button or on/off switch (with battery inserted) is pressed, the battery is outside the operating range of
When the temperature is above 70 ˚C the battery turns off until it’s in the optimum temperature range.
INSERTING AND RELEASING BATTERY PACK
Set Forward/Reversing lever to the center (off position). Slide charged battery pack into the housing until the battery pack locks into position and the red warning label is no longer visible (Fig. 1).
Your battery pack is equipped with a secondary locking latch to prevent the battery pack from completely falling out of the handle, should it become loose due to vibration.
To remove the battery pack, press the battery pack release button and slide the battery pack forward. The red warning label will become
partially visible. Press the battery pack release button again and slide the battery pack completely out of tool housing (Fig. 11).
FIG. 11
CHARGER INDICATORS, SYMBOLS AND MEANING
If the indicator lights are “OFF”, the charger is not receiving power from power supply outlet.
If the green indicator light is “ON”, the charger is plugged in but the battery pack is not
inserted, or the battery pack is fully charged.
If the green indicator light is “BLINKING”, the battery pack is being
charging will automatically stop when the battery pack is fully charged.