Lexicon MC-1 owner manual Specifications

Page 66

MC-1 Digital Controller

7

Specifications

 

 

 

Specifications

Inputs:

Audio:

8 stereo (RCA) pairs

 

Video: 8 composite (RCA), 8 S-video

 

Digital: 8: 5 coaxial (RCA), 3 optical (TosLink), conforms to IEC-958,

 

 

S/PDIF standards; 3 Expansion Ports for 96kHz, 24-bit PCM digital audio

Outputs:

Audio:

8 main (RCA): Left, Center, Right, L&R Sides, L&R Rears, Subwoofer

 

 

3 stereo pairs: 2 Record, 1 Zone 2

 

Video: 3 composite (RCA), 3 S-video: 1 Monitor, 2 Record

Audio:

A/D Conversion:

24-bit Delta-Sigma

 

D/A Conversion:

24-bit Delta-Sigma

 

Frequency Response:

10 Hz – 20 kHz, +0.2dB, -0.3dB, referenced to 1kHz

 

THD+Noise:

Less than 0.005% @ 1kHz, maximum output level

 

Dynamic Range:

105dB minimum, 22kHz bandwidth, referenced to

 

 

 

1kHz @ –60dB below maximum output level

 

Signal-to-Noise Ratio:

105dB minimum, 22kHz bandwidth, referenced to

 

 

 

1kHz at maximum output level

 

Input Level:

2 Vrms for maximum output

 

 

 

(with Input Gain=0 dB); 200mV rms for Dolby level

 

Input Impedance:

100 kΩ in parallel with 150pF

 

Output Level:

6Vrms (System Volume = +12dB)

 

Output Impedance:

100Ω in parallel with 150pF

Video:

NTSC M, PAL and SECAM-compatible

 

Output Level:

1.0 V peak-to-peak

 

Impedance:

75Ω

 

Input Return Loss:

40dB

 

Differential Gain:

<0.5%

 

Differential Phase:

<0.5°

 

Frequency Response:

10Hz to 10MHz ±0.1dB

 

Bandwidth:

>25MHz

 

K Factor:

<0.3%

 

Gain:

 

±0.15dB

 

Signal/Noise Ratio:

>70dB

Power Requirements: 90–250 VAC, 50-60Hz, 35 Watts (universal input);

 

IEC detachable power cord

 

Dimensions: 17.3"W x 11.5"D x 3.6"H (440 x 292 x 92mm);

 

 

Rack mounted: 19.0"W x 11.5"D x 3.5"H (483 x 292 x 89mm)

 

Weight:

10.8 lbs. (4.9kg)

Environment:

Operating Temperature:

32° to 95°F (0° to 35°C)

 

Storage Temperature:

–22°to 167°F (–30°to 75°C)

 

Relative Humidity:

95% max without condensation

Remote Control:

Hand-held, battery-powered infrared remote control unit, uses 2 AA batteries

 

 

Specifications subject to change without notice.

59

Image 66
Contents MC-1 Digital Controller Important Safety Instructions Vigtig information om sikkerhed Wichtige Sicherheitsanweisungen Contents Introduction Using the Documentation Glossary of TermsPage Installation Controls and IndicatorsFront Panel Rear Panel TriggersInstallation Remote ControlConcert Hall Nightclub Press and hold with Connection Location ConsiderationsAC Connections Speaker Connections Wiring ConsiderationsAudio/Video Cables Audio/Video ConnectionsMC-1 Connections LDD-1Video Connections Digital Audio ConnectionsExpansion Port Input Connections AC-3 Ready Laser Disc and LD/DVD Players Digital OutputRestore Factory Defaults EqualizationBass and Treble Level Tilt LoudnessDisplay Adjust Menu Display AdjustmentDisplay Adjust Video On-Screen DisplayDisplay Adjust Menu ON-SCREEN Display Input Configuration Input Gain Analog Inputs OnlyInput Name Restore Input NameInput Level Meters Input Effect FX AssignmentFX Format AutomaticDisc System Configuration PCM Only AC-3 OnlyDTS Only Analog AudioVideo Coax 1-5 and Optical 1-3 Digital Audio InputsRecord/Zone Record/Zone 2 ControlsCH, Party, TV M, and Music remote control only Select and Done remote control onlyDolby, THX, Logic 7, and DTS remote control only VOLPGM Trigger Assignment Speaker ConfigurationCustom Configuration Front L/RCenter SidesRears Surround EX Configuration Setting Output LevelsTHX Configuration Subwoofer OutputOutput Levels Menu Internal Noise Test External Noise TestSubwoofer Peak Limiter LimiterZone 2 Power On Volume Setting Listener PositionPower On Volume Mute LevelSync Delay Calibrate PanoramaOFF Sync DLY Balance Zone 2 BalanceSettings Unlocked Custom Name OFF Assign Custom Name Locking SettingsLock Settings Menu CustomizationMain Menu Effect Adjust Using MC-1 EffectsComparing a modified Effect to the factory preset version Customizing EffectsRestoring the original Effect name Restoring the original parameter values of an EffectNaming your custom Effect Listening to only the MC-1 EffectPCM Effects and Parameters3 PanoramaNightclub PCM Effects and Parameters Concert Hall ChurchCathedral PCM Effects and Parameters Party ChannelMusic Surround PCM Effects and Parameters Music Logic LogicPCM Effects and Parameters TV Matrix Pro LogicTHX Cinema PCM Effects and Parameters Mono Logic PCM Effect ParametersPCM Effects and Parameters PCM Effects and Parameters PCM Effects and Parameters PCM Effects and Parameters AC-3 Effects and Parameters4 AC-3 Status DisplayAC-3 Status AC-3 Effects and Parameters 2-Channel MusicAC-3 Effects and Parameters Logic Dolby DigitalAC-3 Effects and Parameters THX 5.1 Including Surround EXAC-3 Effect Parameters AC-3 Effects and Parameters AC-3 Effects and Parameters DTS Effects and Parameters5 DTS 2-ChannelDTS Music DTS Effects and Parameters DTS Logic DTS FilmDTS Effects and Parameters DTS THX Including Surround EX DTS Effect ParametersDTS Effects and Parameters Troubleshooting TroubleshootingProblem Possible Cause and Solution Troubleshooting Routine Maintenance Restoring DefaultsSpecifications SpecificationsInstallation Worksheet Inputs