FieldServer 1.1 user manual Connection Overview Status Aspect

Page 12

Ruinet Utility User Manual

Page 12 of 46

Parameter

Description

Application

2.3.2.Connection Overview - Status Aspect

Parameter

Description

Connection

The current connection being displayed out of the total number.

 

The use of this variable to determine timeouts is driver dependent and has no

Timer

consistent meaning. In passive drivers this variable may not have been used

at all. In simple poll response drivers this variable should decrease from its

 

 

maximum (equal timeout value) to zero.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com

Image 12
Contents Ruinet Version RevTable of Contents Appendix C Advanced Topics Installation and Setup General OverviewPC Requirements Hardware SoftwareRemote User Interface RuiNet Connecting to a FieldServer FieldServer Information Settings Aspect FieldServer InformationFieldServer Information Settings Aspect Parameter DescriptionFieldServer Information Status Aspect Connection Overview Connection Overview ScreenConnection Overview Settings aspect Connection Overview Settings Aspect Reference source not found. for further informationConnection Overview Status Aspect Connection Overview Statistics Aspect Descriptor. See Error! Reference source not found Parameter Description Connection Overview Error Statistics Aspect NAKConnection Overview API Aspect Parameter Description Node Overview Node Overview ScreenNode Overview Settings Aspect Node Overview Status Aspect Node Overview Operating Statistics AspectParameter Description Node Overview Error Statistics Aspect Map Descriptor Overview Map Descriptor Overview ScreenMap Descriptor Overview Settings Aspect Map Descriptor Overview Status AspectMap Descriptor Overview Operating Statistics Aspect Map Descriptor Overview Error Statistics Aspect Data Array Overview Data Array Detail ScreenError Messages Driver MessagesDownload Configuration to FieldServer Procedure for Downloading a File from a PC to a FieldServerUpload Configuration from FieldServer Procedure to Upload a File from a FieldServer to a PCProcedure to Change a FieldServer’s IP Address Obtain the IP address using the Dhcp ClientChange IP Address Obtain the IP address using the FieldServer’s Dhcp Server Change UI Display Mode Restart FieldServerPage Appendix A.2. File Download Appendix B.2. Connecting to a FieldServer using Name -y Appendix B.3. Broadcast Mode -ibAppendix B.5. Disable Auto Connect Mode -m0 Appendix B.4. The Most Recently Connected FieldServer -pAppendix B.6. Restart a FieldServer -b Appendix B.7. Startup ScreenAppendix B.8. Transferring files -l, -f Appendix B.9. Downloading Files -u0 Appendix B.10. Uploading Files -u1Appendix B.11. Forcing a Download -o Appendix B.12. Number of File Transfer Tries -nAppendix B.14. Set Local File Name for a Transfer -l Appendix B.15. Help -h Appendix B.16. Create a Log File -aAppendix B.17. Version Information -v, -ve Appendix B.18. Skip date and time check on connect -m1Appendix B.21. Set Timeout -k Appendix B.22. Run in Test ModeAppendix B.19. Delete a File -z Appendix C.2. FieldServer Tiers Appendix C.3. Connecting to a FieldServer over the Internet Diagram below shows how this is typically doneAppendix D. Default settings for parameters Parameter Default Setting