Bosch Appliances D9412GV2 # FA Bypass Max, # Auto Watch, # Delay Res, # Exit Tone, # Verify Time

D9412GV2/D7412GV2 Program Entry Guide 2.0 GV2MAIN

EN 38

A# FA Bypass Max

Default: 1

Selection: 0 to 99

Specify the maximum number of combined Controlled points that can be faulted or bypassed when arming this area.

Refer to the prompts P## FA Retrnable and P## BA Retrnable in Section 4.2 Point Responses on page 92 for returning a point to the system when the point returns to normal or when the area is disarmed.

Points programmed for instant alarm response generate alarms immediately, even during exit delay. To avoid instant alarms on points adjacent to the perimeter when leaving the area, program P## Type as 3 (Interior Follower).

For SIA CP-01 Compliance

The Exit Delay Time must be between 45 sec and 255 sec.

A# Auto Watch

Users can bypass more points than the number entered here during the disarmed state. It is only when the user attempts to Bypass Arm an area (or areas) that this restriction is enforced.

A# Delay Res

Default:	No
Selection:	Yes or No
Yes	Point Restoral Report is not sent until
	the bell time expires or user
	acknowledges alarm condition.
No	Restoral Reports are sent when point
	restores, regardless of bell time.

A# Exit Tone

Default: Yes

Selection: Yes or No

Sounds an exit tone during exit delay at all keypads assigned to this area.

You can turn off exit tones for individual keypads by programming the appropriate CC# 1 to 8 as No in CC# Exit Tone.

A# Exit Dly Time

Default: 60

Selection: Blank (0) to 600 ( in 5 sec increments)

Exit delay time for this area when Master Exit or Perimeter Exit arming.

Default:	No
Selection:	Yes or No
Yes	When the area is disarmed, Watch
	Mode turns on automatically.
No	When the area is disarmed, Watch
	Mode must be turned on or off
	manually.

Controlled points must be programmed as P## Watch Point to generate a watch tone.

A# Verify Time

Default: 60

Selection: 10 to 60 (in 1-sec increments)

Use alarm verification with smoke detectors to reduce the number of false fire alarms. When Verify Time is programmed, the control panel can check smoke detector point activations before generating alarm signals.

• Do not enable the Cross Point feature in point indexes designated for Fire points.

•Check with your authority having jurisdiction (AHJ) to determine the maximum verification time allowed.

Points are programmed individually to activate the verification feature. Refer to Section 4.1 Point Index on page 88. Any resettable Fire point can activate alarm verification for the area to which it is assigned. Use separate area alarm-verification relays.

To enable alarm verification on a point, program Point Index, Fire Point, Alarm Verify, and Resettable as Yes.

Bosch Security Systems, Inc. 10/08 F01U003636-04