SkyLink AM-002/ML-001 manual Deactivating the Digital Dialer

INSTALLATION

Deactivating the Digital Dialer

You can deactivate the digital dialer by erase the phone number memory for central monitoring station.

Step	Keys	Function	Description	Note
1	Press [PROG]	Enter Program-	Enter master	3 beeps for valid
	Press [MPIN]	ming mode	password to	password. 1 long
			programming mode	beep for invalid
				password.
2	Press [1]	Select phone		You will hear:
		number		[Enter Phone
		programming		Memory]
3	Press [0]	Enter phone
		memory
4	Press [ARM]	Confirm delete		You will hear
		the phone		[Phone Zero
		number.		Empty Memory]
				indicating the phone
				number have been
				deleted, the digital
				dialer is deactivated.

Note: If no phone number is programmed to call the central monitoring station, the digital dialer is automatically disabled.

–14–

HOME AUTOMATION

Control Module [1] is represented by zone LED 1

®

This row :

Buttons for

Learning Control Module

Part 2 Learn signal from Control Panel to Control Module

Step	Keys		Function	Description	Note
1	Press and hold		Enter		LED on the Control Module
	the learn button		Programming		will flash indicating it is in
	on the Control		mode		learn mode.
	Module until its
	LED starts to
	flash.
2	[6] to [0]		Transmit an ON	Refer to the	After [X] is entered, you
			signal for the	chart below to	will hear [Device X On]
			selected device	determine which	indicating you have trans-
			from the Control	button [6] to [0]	mitted an ON signal for
			Panel to the	to press.	device X, where X is the
			Control Module.	You should	Control Module Location.
				transmit the “ON”	The LED on the Control
				command for the	Module should be off,
				selected device.	indicating it has learned
					the signal, you may now
					release the learn button
					and the LED will stay on
					again.
CONTROL MODULE		TRANSMIT
LOCATION		BUTTON [X]
1			6
2			7
3			8
4			9
5			0

–39–