INSTALLATION
Contact ID Phone number
You can program a telephone number for calling to the central monitoring station. When the system is in panic, the control panel will call this phone number and will send out a Contact ID message with event code 140, which represents “General Alarm”.
Follow the instructions below to program the necessary info in order to call a monitoring station:
-Phone number of central monitoring station (up to 29 digits)
-Account number given by the Central Monitoring Station
Phone Number Programming (Calling to Central Monitoring Station)
Step | Keys | Function | Description | Note |
|
|
|
|
|
1 | Press [PROG] | Enter Program- | Enter master | 3 beeps for valid |
| Press [MPIN] | ming mode | password to | password. 1 long |
|
|
| programming mode | beep for invalid |
|
|
| password. | |
|
|
|
| |
|
|
|
|
|
2 | Press [1] | Select phone |
| You will hear: |
|
| number |
| [Enter Phone |
|
| programming |
| Memory] |
|
|
|
|
|
3 | Press [0] | Enter phone | During emergency, | You will hear: |
|
| memory | the Contact ID phone | [Phone Zero] |
|
|
| number has the highest |
|
|
|
| priority, it will be the |
|
|
|
| first number to call. |
|
|
|
|
|
|
4 | Enter [Phone | Enter phone | Phone number | You will hear |
| number] + | number | can be up to 29 | [Phone Accepted] |
| [Arm] |
| digits. | indicating the phone |
|
|
|
| number has been |
|
|
|
| programmed |
|
|
|
| successfully. |
|
|
|
|
|
| HOME AUTOMATION |
| |
|
|
ZONE LED | DESCRIPTION |
|
|
Off | Zone is not occupied by any control module |
|
|
Flashes twice | That means a remote has occupied that zone. |
| THIS IS NOT A CONTROL MODULE, THEREFORE, SHOULD NOT BE |
| ERASED. |
|
|
Flashes once | That zone is occupied by a control module. You may select this |
| zone to erase this control module. |
|
|
Flashes once, | That means this zone is occupied by a remote AND a control module. |
then twice | You may select this zone to erase the control module. |
|
|
**Table F: Zone LED status for erasing control module.
Part 2 Erase communication from Control Panel to Control Module
Step | Keys | Function | Description | Note |
|
|
|
|
|
1 | Remove the | Enter program- | Enter master | 3 beeps for valid |
| control module | ming mode | password to | password. 1 long |
| from the |
| programming | beep for invalid |
| electrical outlet |
| mode | password. |
|
|
|
|
|
2 | Press and hold | To erase the |
| Control module LED |
| the learn button | memory of the |
| will flash rapidly |
| on the control | control module |
| indicating all the |
| module while |
|
| memory is erased. |
| plugging in the |
|
| You may now |
| control module |
|
| release the learn |
| to an electrical |
|
| button. |
| outlet. |
|
|
|
|
|
|
|
|
Once the memory of the control module is erased, all of its memory is cleared. If you have other remotes / control panels controlling this control module, you need to