VeriFone Vx670 manual Using the Smart Battery, Smart Battery Features

TERMINAL SETUP

Using the Smart Battery

4Insert the SIM into the cardholder.

NOTE

There is only one SIM slot, but there are multiple SAM slots. Make sure you insert the SIM card into the SIM slot, as shown in Figure 16.

Figure 16 Inserting SIM Card

5Install the battery (see Figure 17).

Using the Smart Battery

The Vx670 terminal uses an Li-ion smart battery (see Accessories and Documentation for ordering information). The internal logic of the smart battery prevents both overcharging and undercharging (a fault condition in which the battery level goes well below the minimum acceptable charge and the battery becomes unusable).

NOTE The Vx670 terminal will operate on battery power or on power pack power. The smart battery charger in the terminal will be active whenever the power pack is connected.

Smart Battery Features

The following are features of the smart battery:

•Two Li-ion cells

•A fuel gauge module that:

•monitors state of charge (voltage and percentage of capacity),

•communicates with the terminal (charge parameters and status),

•determines full charge capacity (on charge cycle and uninterrupted discharge cycle), and

•automatically shuts down when cell voltage is extremely low.

•A safety circuit that:

•prevents cell damage from overcharge, over-discharge, or overheating, and

VX670 INSTALLATION GUIDE 25