Sharp EC-T5180B Step, Dirt Compartment, Air Duct Net Filter assembly, Projection Slot, Guide Mark

Page 11

3

4

5

Empty dirt compartment. (Fig.21)

Replace the net filter assembly into the dirt

compartment.
Be sure to match the	marks of the Filter
Compartment and Dust Cup.		Upper Handle

Align the projection of net filter assembly to the slot of dirt compartment and follow the arrow to fit or turn to CLOSE side.

Dirt Compartment

Fig.21

Air Duct

Fig.22

Net Filter assembly

Projection

Slot

Fig.23

Align the rectangular groove to the guide

6 of vacuum cleaner then push to snap into place. (Fig.24)

Alsomarks are on Dust Compartment and Base.

STEP 2

Rectangular Mark

Groove

STEP 1

Guide

Fig.24

Mark

CAUTION: Do not use chemicals, bleach or hot water to clean the dirt compartment. Wash with soap and water using a soft brush. Do not dry with hair dryer or heater.

NOTE: Very fine materials, such as face powder, plaster or fine powder may seal the filters and cause loss of suction. When vacuuming this type of material, be sure to empty the dirt compartment and clean the filters more frequently (before reaching the “Max Fill Line”).

11

Image 11

Contents MODELS CONTENTSVACUUM CLEANER EC-S5170 EC-T5180 EC-T5180A EC-T5180BIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSFRONT SPECIFICATIONSPARTS IDENTIFICATION Dirt Compartment Handle Upper REARCord Storage Hook Carrying Handle Power Cord ON/OFF SwitchOPERATING INSTRUCTIONS HOW TO ATTACH THE HANDLE TO VACUUM CLEANERHOW TO WIND POWER CORD HOW TO RELEASE POWER CORDUpright Position HOW TO RELEASE THE HANDLEHOW TO OPERATE RUG /FLOORSELECTOR PEDAL NOTE Agitator Safety MechanismOPERATING INSTRUCTIONS ON/OFF SWITCHPOWER CONTROL SWITCH EC-T5180series only POWER HIGHHEAT PROTECTION SYSTEM HOW TO USE THE ON BOARD TOOLSHOW TO REMOVE AND REPLACE DIRT COMPARTMENT MAINTENANCE INSTRUCTIONSDirt Compartment Fig.21 Air Duct Fig.22 Net Filter assemblySTEP STEPFilter Cover HOW TO CLEAN THE NET FILTER ASSEMBLYHOW TO CLEAN THE MAIN FILTER Net FilterREMOVE HOW TO REMOVE / AND RESET THE BOTTOM PLATEFig.28 RESET Suction Hose Front channelMAINTENANCE INSTRUCTIONS HOW TO REMOVE THE HEAD COVERHOW TO REPLACE THE MAIN FILTER REPLACEMENT INSTRUCTIONSHOW TO REPLACE THE HEADLIGHT LAMP REPLACEMENT INSTRUCTIONS HOW TO MAINTAIN OR REPLACE THE EXHAUST FILTERSHow to remove/set the filter Motor Shaft HOW TO REPLACE THE BELT AND OR AGITATOR ASSEMBLYAgitator Assembly Main Pulley Fig.41 Idler Pulley Flat BeltFOR CUSTOMER ASSISTANCE BEFORE REQUESTING SERVICETROUBLESHOOTING CHART ProblemPARTS DESCRIPTION DESCRIPTION OF ACCESSORIESPARTS DESCRIPTION PART NUMBEROsaka, Japan CONSUMER LIMITED WARRANTYSHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey SHARP CORPORATIONINSTRUCCIONES DE SEGURIDAD IMPORTANTES ASPIRADORA INSTRUCCIONES DE OPERACIONADVERTENCIA / daños GUARDE ESTAS INSTRUCCIONES ProblemaSERVICIO AL CONSUMIDOR NOTANUMERO DE PARTE DESCRIPCION DE LOS ACCESORIOSARTICULO DESCRIPCION ARTICULOOsaka, Japan GARANTIA LIMITADASHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey SHARP CORPORATION