Sharp EC-S5170, EC-T5180A, EC-T5180B How To Remove The Head Cover, Maintenance Instructions

Page 14

MAINTENANCE INSTRUCTIONS

HOW TO REMOVE THE HEAD COVER

If you find excess dirt or obstructions under the head cover, you can remove the head cover. The head cover is secured by two screws from the bottom side.

Remove the bottom plate, following the	Head Cover
1 instructions on page 13.

Top Tab

Remove the agitator assembly and the belt,
2 following the instructions on page17.	Fig.30

3 Unscrew(Fig.31) two screws at the nozzle head.

Two screws secure the head cover

Fig.31

4 Lift the top tab of the head cover and remove.

5 When resetting the head cover, be sure to fit the three front tabs in the nozzle head.

Three Front Tabs

Fig.32

Image 14

Contents EC-S5170 EC-T5180 EC-T5180A EC-T5180B CONTENTSVACUUM CLEANER MODELSIMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSFRONT SPECIFICATIONSPARTS IDENTIFICATION ON/OFF Switch REARCord Storage Hook Carrying Handle Power Cord Dirt Compartment Handle UpperHOW TO RELEASE POWER CORD HOW TO ATTACH THE HANDLE TO VACUUM CLEANERHOW TO WIND POWER CORD OPERATING INSTRUCTIONSNOTE Agitator Safety Mechanism HOW TO RELEASE THE HANDLEHOW TO OPERATE RUG /FLOORSELECTOR PEDAL Upright PositionPOWER HIGH ON/OFF SWITCHPOWER CONTROL SWITCH EC-T5180series only OPERATING INSTRUCTIONSHOW TO USE THE ON BOARD TOOLS HEAT PROTECTION SYSTEMMAINTENANCE INSTRUCTIONS HOW TO REMOVE AND REPLACE DIRT COMPARTMENTSTEP Fig.21 Air Duct Fig.22 Net Filter assemblySTEP Dirt CompartmentNet Filter HOW TO CLEAN THE NET FILTER ASSEMBLYHOW TO CLEAN THE MAIN FILTER Filter CoverSuction Hose Front channel HOW TO REMOVE / AND RESET THE BOTTOM PLATEFig.28 RESET REMOVEHOW TO REMOVE THE HEAD COVER MAINTENANCE INSTRUCTIONSHOW TO REPLACE THE MAIN FILTER REPLACEMENT INSTRUCTIONSHOW TO REPLACE THE HEADLIGHT LAMP REPLACEMENT INSTRUCTIONS HOW TO MAINTAIN OR REPLACE THE EXHAUST FILTERSHow to remove/set the filter Flat Belt HOW TO REPLACE THE BELT AND OR AGITATOR ASSEMBLYAgitator Assembly Main Pulley Fig.41 Idler Pulley Motor ShaftProblem BEFORE REQUESTING SERVICETROUBLESHOOTING CHART FOR CUSTOMER ASSISTANCEPART NUMBER DESCRIPTION OF ACCESSORIESPARTS DESCRIPTION PARTS DESCRIPTIONSharp Plaza, Mahwah, New Jersey SHARP CORPORATION CONSUMER LIMITED WARRANTYSHARP ELECTRONICS CORPORATION Osaka, JapanINSTRUCCIONES DE SEGURIDAD IMPORTANTES ASPIRADORA INSTRUCCIONES DE OPERACIONADVERTENCIA / daños NOTA ProblemaSERVICIO AL CONSUMIDOR GUARDE ESTAS INSTRUCCIONESDESCRIPCION ARTICULO DESCRIPCION DE LOS ACCESORIOSARTICULO NUMERO DE PARTESharp Plaza, Mahwah, New Jersey SHARP CORPORATION GARANTIA LIMITADASHARP ELECTRONICS CORPORATION Osaka, Japan