Sharp EC-T5180B, EC-T5180A, EC-S5170 Replacement Instructions, How To Replace The Headlight Lamp

Page 15

REPLACEMENT INSTRUCTIONS

HOW TO REPLACE THE HEADLIGHT LAMP

Unplug the vacuum cleaner from the electrical outlet.

1	Remove the dirt compartment.
2
	Unscrew the center screw. (Fig.33)
3
	Lift the lamp cover. (Fig.34)
4		Lamp cover

	Remove the lamp from the socket by pushing in
	gently and turning counterclockwise. (Fig. 35)
5
	Install the new lamp by pushing it gently into the
	socket and turning clockwise. (Fig. 35)
	Use any standard bayonet base vacuum cleaner
	lamp rated 125V, 20W.
6
	Replace the Lamp cover and secure with the
	screw.

Center Screw

Fig.33

Lift

Fig.34

Fig.35

HOW TO REPLACE THE MAIN FILTER

Basically, the main filter can be used throughout the life of the vacuum cleaner.

If you chose to replace main filter, please refer to the maintenance instructions on page 12 which explain how to remove and replace filter.

Filter Cover

Main Filter

Filter Clamp

Top Handle

Grip

Latch Portion

Fig.36

Image 15

Contents MODELS CONTENTSVACUUM CLEANER EC-S5170 EC-T5180 EC-T5180A EC-T5180BIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSSPECIFICATIONS PARTS IDENTIFICATIONFRONT Dirt Compartment Handle Upper REARCord Storage Hook Carrying Handle Power Cord ON/OFF SwitchOPERATING INSTRUCTIONS HOW TO ATTACH THE HANDLE TO VACUUM CLEANERHOW TO WIND POWER CORD HOW TO RELEASE POWER CORDUpright Position HOW TO RELEASE THE HANDLEHOW TO OPERATE RUG /FLOORSELECTOR PEDAL NOTE Agitator Safety MechanismOPERATING INSTRUCTIONS ON/OFF SWITCHPOWER CONTROL SWITCH EC-T5180series only POWER HIGHHEAT PROTECTION SYSTEM HOW TO USE THE ON BOARD TOOLSHOW TO REMOVE AND REPLACE DIRT COMPARTMENT MAINTENANCE INSTRUCTIONSDirt Compartment Fig.21 Air Duct Fig.22 Net Filter assemblySTEP STEPFilter Cover HOW TO CLEAN THE NET FILTER ASSEMBLYHOW TO CLEAN THE MAIN FILTER Net FilterREMOVE HOW TO REMOVE / AND RESET THE BOTTOM PLATEFig.28 RESET Suction Hose Front channelMAINTENANCE INSTRUCTIONS HOW TO REMOVE THE HEAD COVERREPLACEMENT INSTRUCTIONS HOW TO REPLACE THE HEADLIGHT LAMPHOW TO REPLACE THE MAIN FILTER HOW TO MAINTAIN OR REPLACE THE EXHAUST FILTERS How to remove/set the filterREPLACEMENT INSTRUCTIONS Motor Shaft HOW TO REPLACE THE BELT AND OR AGITATOR ASSEMBLYAgitator Assembly Main Pulley Fig.41 Idler Pulley Flat BeltFOR CUSTOMER ASSISTANCE BEFORE REQUESTING SERVICETROUBLESHOOTING CHART ProblemPARTS DESCRIPTION DESCRIPTION OF ACCESSORIESPARTS DESCRIPTION PART NUMBEROsaka, Japan CONSUMER LIMITED WARRANTYSHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey SHARP CORPORATIONASPIRADORA INSTRUCCIONES DE OPERACION ADVERTENCIA / dañosINSTRUCCIONES DE SEGURIDAD IMPORTANTES GUARDE ESTAS INSTRUCCIONES ProblemaSERVICIO AL CONSUMIDOR NOTANUMERO DE PARTE DESCRIPCION DE LOS ACCESORIOSARTICULO DESCRIPCION ARTICULOOsaka, Japan GARANTIA LIMITADASHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey SHARP CORPORATION