Sharp EC-S5170, EC-T5180 Operating Instructions, How To Attach The Handle To Vacuum Cleaner

Page 6

OPERATING INSTRUCTIONS

HOW TO ATTACH THE HANDLE TO VACUUM CLEANER

1 First remove the handle screw. Then slide the base of the handle to the body of the vacuum cleaner as shown. (Fig. 1)

Handle

2 Line up the hole on the handle with the hole on the side of the vacuum cleaner and insert the screw. (Fig. 2)

Be sure the screw is tightened securely.

Handle

Slide

Handle screw

Fig.1

Handle screw

Fig.2

HOW TO WIND POWER CORD

1 Insert the power cord in the clip located on handle as shown. (Fig. 3)

Clip

Fig.3

2 Wrap excess cord around the cord storage hooks to prevent dragging and any interference with cleaning. (Fig. 4)

Upper cord storage hook

Lower hook

Fig.4

HOW TO RELEASE POWER CORD

Rotate the upper cord storage hook downward for quick cord release. (Fig. 5)

Upper cord storage hook

Fig.5

Image 6

Contents EC-S5170 EC-T5180 EC-T5180A EC-T5180B CONTENTSVACUUM CLEANER MODELSIMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONSSPECIFICATIONS PARTS IDENTIFICATIONFRONT ON/OFF Switch REARCord Storage Hook Carrying Handle Power Cord Dirt Compartment Handle UpperHOW TO RELEASE POWER CORD HOW TO ATTACH THE HANDLE TO VACUUM CLEANERHOW TO WIND POWER CORD OPERATING INSTRUCTIONSNOTE Agitator Safety Mechanism HOW TO RELEASE THE HANDLEHOW TO OPERATE RUG /FLOORSELECTOR PEDAL Upright PositionPOWER HIGH ON/OFF SWITCHPOWER CONTROL SWITCH EC-T5180series only OPERATING INSTRUCTIONSHOW TO USE THE ON BOARD TOOLS HEAT PROTECTION SYSTEMMAINTENANCE INSTRUCTIONS HOW TO REMOVE AND REPLACE DIRT COMPARTMENTSTEP Fig.21 Air Duct Fig.22 Net Filter assemblySTEP Dirt CompartmentNet Filter HOW TO CLEAN THE NET FILTER ASSEMBLYHOW TO CLEAN THE MAIN FILTER Filter CoverSuction Hose Front channel HOW TO REMOVE / AND RESET THE BOTTOM PLATEFig.28 RESET REMOVEHOW TO REMOVE THE HEAD COVER MAINTENANCE INSTRUCTIONSREPLACEMENT INSTRUCTIONS HOW TO REPLACE THE HEADLIGHT LAMPHOW TO REPLACE THE MAIN FILTER HOW TO MAINTAIN OR REPLACE THE EXHAUST FILTERS How to remove/set the filterREPLACEMENT INSTRUCTIONS Flat Belt HOW TO REPLACE THE BELT AND OR AGITATOR ASSEMBLYAgitator Assembly Main Pulley Fig.41 Idler Pulley Motor ShaftProblem BEFORE REQUESTING SERVICETROUBLESHOOTING CHART FOR CUSTOMER ASSISTANCEPART NUMBER DESCRIPTION OF ACCESSORIESPARTS DESCRIPTION PARTS DESCRIPTIONSharp Plaza, Mahwah, New Jersey SHARP CORPORATION CONSUMER LIMITED WARRANTYSHARP ELECTRONICS CORPORATION Osaka, JapanASPIRADORA INSTRUCCIONES DE OPERACION ADVERTENCIA / dañosINSTRUCCIONES DE SEGURIDAD IMPORTANTES NOTA ProblemaSERVICIO AL CONSUMIDOR GUARDE ESTAS INSTRUCCIONESDESCRIPCION ARTICULO DESCRIPCION DE LOS ACCESORIOSARTICULO NUMERO DE PARTESharp Plaza, Mahwah, New Jersey SHARP CORPORATION GARANTIA LIMITADASHARP ELECTRONICS CORPORATION Osaka, Japan