Sharp EC-T5180A, EC-S5170 How To Remove / And Reset The Bottom Plate, Suction Hose Front channel

Page 13

WHEN YOU FOUND ANY OBSTACLES IN THE HEAD COVER OR FRONT CHANNEL

If you find some obstacles such as hair, paper slip, are caught inside the head cover or front channel, please try to remove with suction hose of this vacuum cleaner. (Fig.27)

If this is not enough cleaning, please use some wooden stick for picking, or removing bottom plate and / or head cover for cleaning.

Suction Hose

Front channel

Fig.27

HOW TO REMOVE / AND RESET THE BOTTOM PLATE

Before replacing any parts, unplug the vacuum	Four Screws
cleaner from the electrical outlet and release the
handle. Then turn the vacuum cleaner over,
exposing the underside.

REMOVE

Loosen the bottom plate by unscrewing four screws, (Fig. 28) then remove the bottom plate.

Fig.28

RESET

Make sure that all the parts are properly position.

1 Insert the front three tabs of the bottom plate into the grooves at the front end of the nozzle head, then reset the bottom plate. (Fig. 29)

2 Fasten four screws.

Three Tabs

Fig.29

Image 13

Contents VACUUM CLEANER CONTENTSEC-S5170 EC-T5180 EC-T5180A EC-T5180B MODELSIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONSPARTS IDENTIFICATION SPECIFICATIONSFRONT Cord Storage Hook Carrying Handle Power Cord REARON/OFF Switch Dirt Compartment Handle UpperHOW TO WIND POWER CORD HOW TO ATTACH THE HANDLE TO VACUUM CLEANERHOW TO RELEASE POWER CORD OPERATING INSTRUCTIONSHOW TO OPERATE RUG /FLOORSELECTOR PEDAL HOW TO RELEASE THE HANDLENOTE Agitator Safety Mechanism Upright PositionPOWER CONTROL SWITCH EC-T5180series only ON/OFF SWITCHPOWER HIGH OPERATING INSTRUCTIONSHEAT PROTECTION SYSTEM HOW TO USE THE ON BOARD TOOLSHOW TO REMOVE AND REPLACE DIRT COMPARTMENT MAINTENANCE INSTRUCTIONSSTEP Fig.21 Air Duct Fig.22 Net Filter assemblySTEP Dirt CompartmentHOW TO CLEAN THE MAIN FILTER HOW TO CLEAN THE NET FILTER ASSEMBLYNet Filter Filter CoverFig.28 RESET HOW TO REMOVE / AND RESET THE BOTTOM PLATESuction Hose Front channel REMOVEMAINTENANCE INSTRUCTIONS HOW TO REMOVE THE HEAD COVERHOW TO REPLACE THE HEADLIGHT LAMP REPLACEMENT INSTRUCTIONSHOW TO REPLACE THE MAIN FILTER How to remove/set the filter HOW TO MAINTAIN OR REPLACE THE EXHAUST FILTERSREPLACEMENT INSTRUCTIONS Agitator Assembly Main Pulley Fig.41 Idler Pulley HOW TO REPLACE THE BELT AND OR AGITATOR ASSEMBLYFlat Belt Motor ShaftTROUBLESHOOTING CHART BEFORE REQUESTING SERVICEProblem FOR CUSTOMER ASSISTANCEPARTS DESCRIPTION DESCRIPTION OF ACCESSORIESPART NUMBER PARTS DESCRIPTIONSHARP ELECTRONICS CORPORATION CONSUMER LIMITED WARRANTYSharp Plaza, Mahwah, New Jersey SHARP CORPORATION Osaka, JapanADVERTENCIA / daños ASPIRADORA INSTRUCCIONES DE OPERACIONINSTRUCCIONES DE SEGURIDAD IMPORTANTES SERVICIO AL CONSUMIDOR ProblemaNOTA GUARDE ESTAS INSTRUCCIONESARTICULO DESCRIPCION DE LOS ACCESORIOSDESCRIPCION ARTICULO NUMERO DE PARTESHARP ELECTRONICS CORPORATION GARANTIA LIMITADASharp Plaza, Mahwah, New Jersey SHARP CORPORATION Osaka, Japan