HP PE4240N 42 inch manual Setting up VGA, Selecting color system

NOTE: The Channel options are 1, 2, 3, or 4. A broadcast may contain other closed caption data on channels 2–4; for most uses, set the channel to 1.

8Highlight and select Display so it turns red. Adjust the setting so it reads either Shadow or Box, and then press Setting front panel button (Enter on the remote control).

9Exit the menu.

Setting up VGA

Use this procedure to select the VGA source signal type (Normal is 640 x 480, Wide is 852 x 480).

1Display the OSD menus. Refer to “Using the On Screen Display (OSD) Controls” on page 28 for steps to open and use the menus using the front panel buttons (or the remote control buttons).

2Select and display Configuration menu.

3Highlight and select VGA Source so it turns red. Adjust the setting so it reads either WIDE or NORMAL, and then press Setting front panel button (Enter on the remote control).

4Exit the menu.

Selecting color system

Select the color system for the Video input as Automatic, NTSC, or PAL input using this procedure.

1Display the OSD menus. Refer to “Using the On Screen Display (OSD) Controls” on page 28 for steps to open and use the menus using the front panel buttons (or the remote control buttons).

2Select and display Configuration menu.

3Highlight and select Color System so it turns red. Adjust the setting so it reads Auto, NTSC, or PAL, and then press Setting front panel button (Enter on the remote control).

Using the TV 51