Installing and Using HP LocalDirector Controller
Configuring HP LocalDirector Controller
the Cisco LocalDirector gateway to configure the
Refer to Cisco LocalDirector’s manuals for information on setting this parameter and other configuration information.
Configuring HP LocalDirector Controller
There are two components you need to configure before using HP LDC: the HP LDControl server and the HP LDControl daemon.
Follow these steps:
1.Start the HP administration server. Type the following:
/opt/webqos/admserv/start-admin
2.Start a browser that supports frames, is
3.Go to the URL
http://hostname:8282
where hostname is the name of the system on which you are running the HP server.
Reload this page to retrieve the current information, even if it has been visited prior to this installation.
4.Enter the following administration user (server) ID and password:
User ID: hpadmin
Password: Enter the password you configured when you ran
/opt/webqos/admserv/setup after installation.
If you are starting the HP server for the first time, the LD Control page to configure the HP LDControl daemon is displayed (see Figure
142 | Chapter 6 |