Originals are curling up in the scanner output tray
Under dry conditions, lightweight originals such as those printed on carbonless copy paper may curl in the output tray. To minimize curl, flatten curled edges on the originals before placing them in the document feeder. If you cannot flatten curled edges, make sure the curled edges are facing down when you place the originals in the document feeder.
The bottom of the scanned image is cut off
By default, the scanning software can scan media that is up to 356 mm (14 in) long. For longer pages, the end of the document is not included in the scanned image.
Verify that you have specified an appropriate page size in the scanning software. See also
Scan long documents
The scanned images have streaks or scratches
After each step, try another scan to see if the streaks or scratches are still apparent. If so, then try the next step. For information on cleaning the scanner, see the Care and maintenance section.
yCheck that the originals are clean and unwrinkled.
yClean the glass strips inside the document feeder.
yClean the rollers.
See also
Care and maintenance
An item loaded in the scanner jams repeatedly
yThe item might not meet the guidelines for acceptable originals.
yThe item might have something on it, such as staples or
yMake sure the paper guides touch the edges of the original.
See also
Load originals
Clear jams from the scanner paper path
To clear a paper jam:
1.Open the scanner hatch.
2.Remove the originals or any obstructions from the paper path.