hp photosmart 1315 color printer
loading paper in the IN tray
You can load many different types of paper in the IN tray, including plain paper, HP Photo Paper, and HP Premium Inkjet Transparency Film.
To load paper in the IN tray:
1Lift the OUT tray.
2Pull out the IN tray by using the handles on the side of the tray.
3Pull out the paper length guide on the IN tray and slide the paper width guide as far to the left as it will go.
4Place a stack of paper into the IN tray.
•Load the paper printing side down. The printer prints on the
•Always load paper in the portrait direction, with the long edge along the long edge of the IN tray.
|
|
|
|
|
|
|
|
Paper width | Paper length | ||
guide | guide | ||
•Be careful not to use too much or too little paper. It may be difficult for the printer to “grab” a sheet of paper when there are only one or two sheets in the IN tray. Check that the stack of paper contains several sheets but is no higher than the top of the paper length guide.
•Use one type and size of paper at a time. Do not mix paper types or sizes in the IN tray.
5Move the slider (visible through a slot in the OUT tray) toward you until it stops. This disengages the photo tray.
6Adjust the paper width guide and paper length guide to fit close to the edges of the paper without bending the paper. This helps the paper feed straight into the printer.
7Slide the IN tray back into place and lower the OUT tray.
8 | printer basics |